I have a check engine light on and i can get a scanner to link up to obd2 link , is there a fuse if so whick one it doesnt state anywhere in the fuse diagrams
SOURCE: 2002 subaru wrx
I have pulld several subby trans and the most common problem seen is dowel pins frozen into alluminum on both sides of bell housing---usally get apart by drivng pins inward towards front of car/ about half way .
SOURCE: subaru 2002 wrx bov dump valve
Is it a vent to air or recirculating one. Also it depends on manufacture, some are quieter than others, higher boost pressure will also make it sound louder but other factors are involved with this so I should take advise from your local shop.
SOURCE: how to change a wheel bearing in a 2002 subaru wrx
i assume we are talking about a press in bearing. they sell a tool called a hubshark or hubtammer they are both the same thing and they allow you to change the bearing with out removing the knuckle. just unbolt the lower ball joint and pull the axle out of the way but use a slide hammer to remove the hub before you unbolt the lower ball joint. then press the bearing out of the knuckle with the tool i mentioned above or take the whole knuckle up to a parts store that can press the bearing out for you carfull of the abs exciter ring if equiped its easy to break.
SOURCE: my 2002 Subaru wrx blower/fan motor cuts off when
Possible bad ground circuit for the blower motor. Start checking your connections.
SOURCE: 1995 subaru impreza wrx sti overboost problem
Do you have a manual boost controller (mbc) installed? I have a 96 WRX and had the same problem and so took out the MBC. It now runs sweet. If you don't have one check the vacuum hoses from the turbo to the wastegate and also to the boost control solenoid, make sure they are tightened with cable ties or a hose clamp. Also could be your spark plugs make sure you have iridium ones, they out perform any others.
2,453 views
Usually answered in minutes!
×