Reading saab 900s obd codes

SOURCE: Looking for OBD I Code Reader for 1995 SAAB 900SE v6

www.ToolSource.com

SOURCE: Radio code for 1997 saab 900s

I'm afraid if you don't have the code, you will have to take it to a local dealer or specialist radio store to have it re-coded.

Fortunately, it's not expensive.

SOURCE: How do you read the oil level correctly on

All dipsticks have an upper and lower mark ..the top mark is the full mark and the lower mark is the add oil mark. Check it with the engine off on level ground.  Also after the motor running at take a few minutes for the oil to return to the oil pan to get an accurate reading.  
Do not overfill.

SOURCE: don't knwo whr obd connector is found on 1996 saab 900 s

is it a 16v saab with engine code B202 if so it is a three pin connector in the right hand side fuse box. that where auto data is showing it anyway. 

mx5turbo92

• 545 Answers
• Posted on Jun 04, 2009

SOURCE: remove/replace shock absorber assembly 900s 1995 saab

1. Slightly loosen hub center nut when all four wheels are on ground.
2. Raise and support vehicle, then remove five wheel bolts and wheel.
3. Remove hub center nut, then the wheel sensor,
4. Press back brake piston using slip-joint pliers,
   
5. Remove caliper from steering swivel member, then suspend in wheel housing with cable tie.
6. Remove brake disc and back plate, then slightly loosen tie rod end nut.
7. Press out tie rod end nut using puller tool or equivalent.
8. Remove nut and tie rod end bolt, then the anti-roll bar to swinging arm nut.
9. Remove outer ball joint nut.
10. Press ball joint out of steering swivel member using puller tool or equivalent, installed on spring link.
11. Remove nut and discard. This self-locking nut must not be reused.
12. Remove three upper mounting nuts for MacPherson strut, then the strut.
13. Clamp MacPherson strut in vice.
14. Compress spring using spring compressor or equivalents.
15. Hold piston rod and remove nut using MacPherson strut socket tool 89 96 662, or equivalent. This is a self-locking nut and must not be reused.
16. Remove mounting and top spring seat, then the coil spring, gaiter and compression stop.
17. Unscrew damper using wrench tool No. 89 96 670, or equivalent, then remove damper from strut.
18. Reverse procedure to install, noting the following:

1. Screw damper in place using wrench tool No. 89 96 670, or equivalent.
2. Lower end of coil spring should abut against stop in bottom of spring cup.
3. Position MacPherson strut on vehicle and install three retaining nuts on top mounting. Tighten nuts alternately, according to specifications.
4. Always use new hub center nut with self-locking threads.