I have tried to clear some snow which were on the windscreen, wipers got stuck half way through and now its not working at all, I thought the windscreen arms might have loosened, but looks like its not it. cant here any noise when the wipers are activated, can any one give bit of advice??? Regards Sam
Check your fuse compartment under hood. Fuse 3 & 12 for windshield wipers and washers. More than likely you've overloaded the wiper motor causing a blown fuse.
Check this site for additional fuse information: Peugeot 407 2006 fuse box diagram Auto Genius
SOURCE: i have a peugeot 1007 and my windscreen wipers
hi first that you have water in your bottle then using a pin unblock the window jets hope that helps
SOURCE: peugeot 1007 windscreen washer water jets
This happened to me too - several times. Fix by changing fuse number 10 and it works a treat!
SOURCE: Windscreen wiper snapped-Peugeot 206 Verve 52 plate
this just happened to us, the drivers side stopped working after getting tangled up with the passenger side...it was just a case of tightening up the 13mm nuts on the wiper arm.
SOURCE: Why does my Peugeot 206cc windscreen wipers keep
Auto water detection system on the windscreen sets them off
SOURCE: Windscreen wipers not working on peugeot 206hdi
The relay for these should be in the motor assembly itself. If there is no power getting to the motor, replace the switch on the column. This should rectify the issue. I have a manual for a 406 if that may be of some assistamce to you.
1,032 views
Usually answered in minutes!
×