Cup holder is stuck down

Dash Cup Holder is stuck and won't come out, how do I fix ...

www.fixya.com/.../t10005627-dash_cup_holder_stuck_won_39_t_come

Aug 5, 2011 - Dash Cup Holder is stuck and won't come out, how do I fix it? - Saab 2004 9-3 ... How do I remove an in-dash cup holder in my 2005 Chevy Malibu. Apr 26, 2014 ' 2005 ... Nov 05, 2012 ' 1999 Pontiac Montana · 1 Answer ...

cup holder montana van Questions & An

There should be a rubber mat in the bottom of the cupholder that is removable for cleaning. The housing itself should be able to be washed with a warm soapy water solution then re-install the rubber mat.

Hi. This is an easy do. With the cup holder fully extended, slide a flat puddy knibe into the top **** between the cupholder and the the dash. slide it side to side to disengage the stops that are part of the cupholder while pulling out lightly on the cupholder. It should come out without much effort. To reinstall, just push the replacement cupholder into the slot. Good luck!

the center console will prob. have to be removed , there are hiden screws, be patiant and thuroly look before just ripping out cup holder.

This is a very very common problem... your best bet is to get a replacement... the GM guys didnt design out cup holders very well

I had a problem with the back seat cup holders. You can actually remove the whole console. I took mine to the dealer and they fixed it for free. They did not even sell me my car. Here is the link to the manuals:

http://www.onlinefreeebooks.net/automotive-machinery-power-equipment-ebooks/volvo/volvo-xc90-owners-manual-pdf.html

I hope this helps!

1. Tilt the cupholder down.
2. Remove the screws holding the cupholder to the instrument panel (IP).
3. Remove the cupholder from the vehicle.

u need to take apart the center console..once u remove the cup holder u need to file down the little nibble just a tad bit and it will work just fine

For the indash center cupholder, you need to remove that odd-shaped panel directly below it on the lower dash. There is 2 screws you can remove from there and then there are 2 more on the sides of the cup holder you can see from the front when the holder is in the open position... be patient and wiggle it around a little it will come out of there!

Let me know how you do..

I recently had to retrieve a small object (camera battery) that was dropped in the cup holder. The battery allowed the cup holder to close properly, but it would not allow the cup holder to open all the way, making the cupholder useless. Getting access to remove the object was quick and easy - all it takes is a small flat blade screw driver. Use the screw driver to gently pry up the wood trim panel in front of the cup holder. Be sure to pull it up evenly from both sides and it will pop out of its retaining sockets. You'll then have the access you need. When you've finished, just realign the wood trim piece and tap it back into place. You can see a picture of where to pry at http://info5000.com/LS400_trim.jpg