2006 pontiac pursuit
Gm and Chevy fob can be programmed at home. I have done it my self for a 01 chevy a 03 sunfire.
The steps on
Step 1 of 5
Get in your Pontiac G6 and make sure all the doors and the trunk are closed.
Step 2 of 5
Put your key in the ignition and hold the "Lock" button on the driver's car door.
Step 3 of 5
Turn the G6 key in your ignition from "On" to "Off" while holding the "Lock" button, and do two more cycles of "On" and "Off" in quick succession.
Step 4 of 5
Release the "Lock" switch on your door and press and hold the "Lock" button on your keyless remote for 10 to 15 seconds.
Step 5 of 5
Remove the key from the ignition of your G6, and test the programming.
Or
Or
Step 1 of 9
Enter your vehicle and close all of the doors behind you besides the driver's door. Be sure to have your keyless remote and ignition key in hand.
Step 2 of 9
Insert and remove the key from the ignition twice in a row and then close and open the door twice in a row.
Step 3 of 9
Insert and remove the key from the ignition again and close and open the driver's door two more times.
Step 4 of 9
Insert the key into the ignition and close the driver's door.
Step 5 of 9
Cycle the key in the ignition "On" and then "Off" and then remove the key from the ignition.
Step 6 of 9
Wait for the locks to cycle to indicate the beginning of the programming sequence.
Step 7 of 9
Press and hold the unlock and lock buttons on your remote for two seconds and then release.
Step 8 of 9
Press and hold just the
lock button on the remote for three seconds and wait for the locks to cycle to indicate successful programming.
Step 9 of 9
Repeat steps seven and eight to program any additional remotes and open the driver's door to end the programming sequence once you are finished.
Hope this helps
SOURCE: how do i program a key fob for a 2006 Pontiac
you will need to take it to a dealer or some place that has a scanner to program key fobs
IMORTANT TAKE ALL THE KEY FOBS WITH YOU
once the vehicle is put in the learn mode all the fobs have to be programed
SOURCE: need to program fob l22733524
GM FOBS cannot be reprogrammed at home...Dealer ($90-125) or go to a local car stereo shop and get their new keyless entry installed ($89)
Good Luck
SOURCE: 2006 pontiac g5 pursuit
go to an Advance Auto parts or an Autozone and they can use their OBD to determine what the light is on for ......the service is free
SOURCE: programing instructions for buick 2006 lacrossekeyless remote fob
Transmitter ProgrammingImportant:
All transmitters which are to be recognized by the remote control door
lock receiver (RCDLR) must be programmed in a single programming
sequence. If the system is placed in program mode it will erase all
previously programmed transmitters upon the receipt of the programming
signal from the first transmitter. Up to 4 transmitters can be
programmed. Do not operate or program the transmitters in the vicinity
of other vehicles that are in the keyless entry program mode. This
prevents the programming of the transmitters to the incorrect vehicle.
Good luck
SOURCE: 2006 pontiac pursuit ignition or shifter
Follow link below it is a common problem that I too found out the hard way will never buy gm again
http://ww2.justanswer.com/uploads/Bluegorilla/2009-11-12_174938_Cobalt_shifter_key.pdf
3,555 views
Usually answered in minutes!
×