Door handle stuck

SOURCE: Reprograming a keyless remote

program transmitter code(s) as follows:
1) Confirm that all the doors are closed and the ignition key is out of the ignition cylinder.
2) Open the driver’s door. Insert the key and turn the ignition switch to ON position within 10 seconds.
3) Turn the ignition switch to OFF position within 10 seconds, remove ignition key from lock cylin-der.
4) Push and release the driver’s door switch (1) 3 times within 20 seconds.
5) Insert the ignition key and turn the ignition switch to ON position within 10 seconds.
6) Turn the ignition switch to OFF position within 10 seconds, remove ignition key from lock cylin-der.
7) Press and hold both LOCK and UNLOCK buttons (2) on the transmitter (3) for more than 5 seconds
within 20 seconds of removing the ignition key from the lock cylinder in step 6.
8) Press LOCK or UNLOCK button (2) on the transmitter (3) within 5 seconds (after step 7). All the
doors will lock/ unlock to confirm that this process has been properly done.
With this process, the transmitter has been programmed.
9) If you want to program an additional transmitter, repeat the procedure from Step 1) through Step 8).
10) Make sure that the keyless entry system properly operates by operating each transmitter.

ZappaNut

• 960 Answers
• Posted on Dec 15, 2008

SOURCE: reprogram keyless entry system

1991-94 Nissan Maxima key less entry reprogramming procedure:

1. Enter the *original code found under the dashboard.
(*the code begins with the letter F and has 7 digits)

2. Close the doors and lock all of the doors,
enter the 7 digit code ( make sure you have your key in hand).

3. Once the code is entered correctly you will hear a long beep ♪ ♫.
While the beep ♪ ♫ is sounding ... ENTER your NEW 4 digit code, (you will then hear random beeps ♪ ♫)
Do not touch anything until the beeping ♪ ♫ stops.

4. To open the doors, the front windows and the trunk,
type: S(Clear) and the New 4 digit code and the door will open automatically.

5. IF by any chance you forget your new code. Just enter the original one and start all over.

SOURCE: Door will not open on 1998 V70 wagon

You have a broken latch that you will need to access from inside the car. Remove the door panel carefully and have a magnetic pickup tool handy to fish in the bottom of the door for any parts that fell to the bottom when the latch let go. To cheat, remove the door panel from the rear door too and you can see what is missing from the broken one.

SOURCE: Alarm haywire, can't override anti-theft system or turn on car

The Alarm on my Mercedes ML320 sounded every night, then it started doing it more often, Showed it to the dealer he says it's the 'Tow Sensor', that needs to be repaced. $700, down the drain. I have already started hating this car, it eats $500-600, every 6 months...

Colin Stickland

• 22516 Answers
• Posted on Nov 20, 2009

SOURCE: using the remote or the door lock inside the car not working

remove the door panels and give everything in sight a good squirt of engine oil in a proper oil can .DO NOT USE THAT SPRAY FISH OIL STUFF ,wd40