Front turn signal bublb replacement

Question 1

0helpful

1answer

Change turn signal bulb 2008 srx

Front turn signal bulb replacement 2008 SRX . Jack up car & block . Remove front wheel & front half of the wheel house assemble. There are about 7 plastic pull rivets that have to be removed . Pull out the wheel house . Remove turn signal & driving light cover held on by 6 # T10 torx screws . Twist out socket & replace bulb # 3757NAK . Should take about 45 min.

Mar 26, 2012 • 2006 Cadillac SRX

0helpful

1answer

One of my turn signals bublbs got busted in the carrier so i replaced the bulb and now when i turn the turnsignals on a solid light comes on i checked the block fuse and the reagular fuse and my four way...

1- you probably installed the wrong type of bulb.
2- you got a short in the socket.
3- stuck flasher relay.

hope this helps.

Aug 19, 2011 • Volkswagen Jetta Cars & Trucks

2helpful

1answer

Replace turn signal bulb

The procedure to replace the REAR turn signal light bulb is as follows:- 1) There are three wing nuts on the inside of the trunk for each tail light. 2) Remove the piece of plastic just inside the trunk where the latch is. 3)Then remove the two thumb screws that the cargo net is attached to and the piece can be pulled up. 4)Them pull the carpeting away from the area where the tail light is located. 5)properly remove the three thumb screws. 6) Keep the bulb handy so you can fit the new bulb as the old bulb is removed out. The procedure to replace the FRONT turn signal is as follows:-- 1) First remove the front headlight assembly.And the bulbs . 2) Open the hood to remove the headlight assembly. 3) Pull the headlamp assembly straight out from the vehicle (moving the headlamp up and down slightly may help to remove it easily). 4) Front turn signal is located below the headlamp assembly (turn/parking lamp on top and the fog lamp is below it). 5) Then turn the bulb socket 1/4 turn counterclockwise to remove it from assembly. 6)Then pull the old bulb from the socket and replace it with a new one. Thanks. you can rate this solution and show your appreciation.

May 21, 2010 • 2005 Pontiac Grand Prix

0helpful

1answer

How do you change a front signal bulb on a 2004 accord

Front turn signal bulb replacement

1. Remove the inner fender
2. Disconnect the 3p connector from the front turn signal/side marker light.
3. Turn the bub socket ( 45 degree ), counterclockwise to remove the bulb.
4. Install a new bulb in the reverse order of removal.

Apr 12, 2010 • 2004 Honda Accord

1helpful

1answer

Cannot find out how to replace the front turn signal on a 1990 Ford Bronco.

The bulb is inside the back of the signal and you'll have to twist the plastic piece in the back counter clock wise a quarter of a turn and pull back. It might have a tab on it that needs to be pushed in first before it will rotate. The space is kinda tight so you may need to pull the headlight assembly out to get to the back of it. You should be able to reach w/o doing that though. Use the light bulb box at Wal-mart to find the right replacement bulb or visit a auto parts store. It either takes a 194 bulb or a 3157 bulb. I believe it's the 194 bulb.

Mar 28, 2010 • 1994 Ford Bronco

0helpful

1answer

I have a left front clearance light out how do you get it out 1

Signal and Marker Lights REMOVAL & INSTALLATION Front Turn Signal and Parking Lights

Disconnect the negative battery cable.
At the rear of the front bumper, turn the bulb socket 1⁄4 turn and remove the socket from the parking brake housing.
Remove the bulb from the socket; if necessary, replace the bulb.
If lens replacement is necessary, remove the retaining bolts and remove the lens from the bumper.
To install, reverse the removal procedures. Check the turn signal/parking light operations.

Fig. 1: Common front turn signal/parking light mounting

Fig. 2: Twist and remove the bulb socket from the back of the turn signal/parking light lens

Fig. 3: If lens removal is necessary, loosen and remove the retaining bolts

Jul 24, 2009 • 1992 GMC Sonoma

0helpful

1answer

Front turning light does not work, i replaced the bulb, and when i turn the truning signal does not turn off.

Sounds like you have a bad ground. Follow the wiring harnesses under the hood and in the trunk, there should be a ground wire going to the chassis or to the body. If they are all clean and tight, you might be looking at a bad light socket.

May 28, 2009 • 1996 Dodge Neon

0helpful

1answer

How do you replace the front turn signal bulb on a 2001 bmw 325 ci

you have to squeeze your hand through the gap in the engine bay turn the casing to unlock the bulb from the hosing remove the bulb and replace it.
For more room to manouvre remove the air filter box and you will have plenty space

Dec 13, 2008 • 2001 BMW 325

1helpful

1answer

Cannot see how to replace the front turn signal on a 98 camery

Open the hood. Locate the phillips screw that holds a plastic tab, from the signal lamp housing, onto the metal support, near/above the outer edge of the headlamp. Remove the screw. The turn signal lamp assembly pulls straight out, towards you. It may be rather tight, if it has never been replaced before. The bulb is replaced by turning the socket that hooks onto the inside of the lamp assembly.

Nov 24, 2008 • 1998 Toyota Camry

1helpful

2answers

Front turn-signal bulb burned out.

It is a tight squeeze, but you can get your arm down past the headlight to the brake cooling duct and pull the brakeduct off the nose of the car back and to the side. Then you can reach through that hole and replace the turn signal blub

Jun 13, 2008 • 2001 Chevrolet Corvette

Question 2

Anonymous

Master 1,586 Answers
Posted on Oct 19, 2008

Anonymous

Master

Joined: Jul 21, 2008

Answers

1586

Questions

0

Helped

820926

Points

5018

The only real way to do this is to remove the headlight assembly. There are two T30 Torx bolts on the top brackets for the headlight - remove those. The third bolt is harder to see. In the top of the fender, down over the headlight, there is a round hole. Shine a flashlight down there and you'll see the third Torx bolt. Unscrew that and then use one of those $1 magnetic retrieval tools they sell at the parts store to pull the bolt out.

Once these three bolts are out, you can manipulate the headlight out of the front of the car. From that point it's easy to replace the bulb. Reassembly is the reverse of removal.

Related Topics:

Trustworthy Expert Solutions

Front turn signal bublb replacement

1 Answer

Anonymous

Add Your Answer

Attachments: Added items

Related Questions:

Change turn signal bulb 2008 srx

One of my turn signals bublbs got busted in the carrier so i replaced the bulb and now when i turn the turnsignals on a solid light comes on i checked the block fuse and the reagular fuse and my four way...

Replace turn signal bulb

How do you change a front signal bulb on a 2004 accord

Cannot find out how to replace the front turn signal on a 1990 Ford Bronco.

I have a left front clearance light out how do you get it out 1

Front turning light does not work, i replaced the bulb, and when i turn the truning signal does not turn off.

How do you replace the front turn signal bulb on a 2001 bmw 325 ci

Cannot see how to replace the front turn signal on a 98 camery

Front turn-signal bulb burned out.

Not finding what you are looking for?

2000 A4

Change turn signal bulb 2008 srx

Ask a Question

Check Out the Latest Top Trucks Report!

Top Audi Experts

ZJ Limited

Thomas Perkins

Ronny Bennett Sr.

Are you an Audi Expert? Answer questions, earn points and help others

Manuals & User Guides

. 2000 A4 Manual

Related Topics:

Trustworthy Expert Solutions

Front turn signal bublb replacement

1 Answer

Anonymous

Add Your Answer

Attachments: Added items

Related Questions:

Change turn signal bulb 2008 srx

One of my turn signals bublbs got busted in the carrier so i replaced the bulb and now when i turn the turnsignals on a solid light comes on i checked the block fuse and the reagular fuse and my four way...

Replace turn signal bulb

How do you change a front signal bulb on a 2004 accord

Cannot find out how to replace the front turn signal on a 1990 Ford Bronco.

I have a left front clearance light out how do you get it out 1

Front turning light does not work, i replaced the bulb, and when i turn the truning signal does not turn off.

How do you replace the front turn signal bulb on a 2001 bmw 325 ci

Cannot see how to replace the front turn signal on a 98 camery

Front turn-signal bulb burned out.

Not finding what you are looking for?

2000 A4

Change turn signal bulb 2008 srx

Related Topics

Ask a Question

Popular Questions

Warning light on dashboard. Orange

P1588 Audi fault code . For engine mount sensor

I can't open hood of

Where is the fuse located

Spark plug gap for Audi A4 2.0T

Check Out the Latest Top Trucks Report!

Top Audi Experts

ZJ Limited

Thomas Perkins

Ronny Bennett Sr.

Are you an Audi Expert? Answer questions, earn points and help others

Manuals & User Guides

. 2000 A4 Manual