1992 Plymouth Voyager Logo

Related Topics:

virgil duzon Posted on Sep 03, 2017

Transmission lost reverse and forward gears will only go in 1st and 2nd gears then rpm goes up and then won't shift anymore until i turn it off then restart again

A604 transmission lost reverse and only has 1st and 2nd gears.I'm able to drive half a block then rpm on motor goes high and no more gear engagement on transmission until i shut it off and then restart. I just replaced input and output sensors about 3 weeks before this problem occured due to transmission shudder and it fixed the problem and now this problem comes up.

3 Related Answers

Anonymous

  • 106 Answers
  • Posted on Jan 16, 2009

SOURCE: 96 plymouth voyager no shift

you say the fluid looks good... that's great.
now next time your out drive for about ten good minuetes long enough for the transmission to get nice and warm and then pull over to nice level ground and with the vehicle in park check the fluid again. it's kind of hard to read because it always has a lot of bubbles on it and stuff. but it may be low on fluid.. good-luck ray

Ad

Anonymous

  • 1 Answer
  • Posted on Apr 29, 2009

SOURCE: Voyager transmission problem

I had the same problem in my 1999 plymouth voyager. Changed both speed sensors it started shifting perfectly.. Now i get a little thump when downshifting from 2nd to first when stoping change the sensors there only about 20 dollars each its 2 of them on the front of transmission..

Azrael SRL

  • 11800 Answers
  • Posted on Oct 10, 2011

SOURCE: transmission won't shift out of 1st gear

You will have to check the valve assembly- the part in your transmission that controls the gear shifting. In this model of transmission it's purely hydraulic so most likely one of the pressure release valves is stuck.
This is an very complex job that must be done only by an experienced mechanic. So either locate a repair shop specialized in transmissions or replace the entire transmission with a good second-hand one.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2001 dakota auto transmission will not shift automatically

You lost your 2-4 and that is normally the Band or Drum
1helpful
1answer

2003 chevrolet cavalier, manual transmission lost 2nd, 4th and reverse but still has 1st, 3rd and 5th gears.

Sounds like one of the levers inside the transmission is either broken or otherwise disengaged. Remove the shifter to see if you can see any obvious reason.
0helpful
1answer
1helpful
1answer

Heres the symptoms : engages but slips in reverse and drive, sometimes feels like partial brake applied. I have manual 1st and 2nd. When engaged in drive, you turn off overdrive and you can spin the...

it may be a bad transmission modulator valve located on the side of your transmission,vacum operated. a sudden downshift or forward shift when unexpected is sign of a bad modulator valve or a vacum leak to the transmission.best to shop around for a garage w/references when it comes to transmission work though. check all the vacum lines to your transmision,you need to look on the underneath side of your truck on the side of transmission for a loose or disconnected vacum line on the side of the transmission. when you feel the vacum line,follow it to the top of engine,the vacum line is about 3/8th line,and may be disconnected or losing air. to make this short,when you drive the car,start out in low gear and shift the transmission,manually from 1st to 2nd to 3rd does it do right with no slipping? if it does this right and shifts great manually,the modulator valve on the side of the transmissions bad,or a bad vacum leak in-between.thank you for choosing fixya.com
0helpful
1answer

My 2001 GMC Jimmy 4x4 Automatic with 84K miles. It winds when I put it in reverse and I think I only have 1st and 2nd gear. Additionally it revs high, like over 3000 rpm, delays and then eventually...

It winds up in 1st and then shifts right from 1st into 3rd. Then never shifts into 4th. Plus rev is gone. You broke the sun shell. The transmission will need to rebuilt or replaced.
0helpful
1answer

Only reverse works. No foward gears.

No forward movement in OD or D, but L2, L1 and R work: Forward sprag is broken. R&R. Try not to run or drive the car or further damage could result.

Do you have manual 1st? If so, can you shift through the gears...i.e. manual 1st to manual 2nd then 'D' then 'OD'??? Only 1st and 2nd gears use the forward sprag unless the LO/Rev clutch is engaged...i.e. 1st and 2nd if in "drive". If you can shift threw the gears manually then, yes, your forward sprag broke.

If no manual 1st then your sprag is not what broke. Sounds like you blew up the rear planet. If you pull the pan and find chunks of iron and steel, then that is probably what happened. If you have reverse then it is not the pump. If the pump was bad you would have no line pressure and it would slip in rev. or no rev. Not the beef sun shell either because you have rev., a broken sun shell would cause no 2nd, 4th and rev. gears. Either way the trans needs to come out and torn down and it will be easily found what went. Good luck and thank you for using Fixya.
1helpful
1answer

4L 60E - 2001 k1500 will not shift into 3-4. Oil is not burn't and stifts great into1-2

  • No 3rd or 4th gear: “3-4” clutches are worn out. R&R. The car is safe to drive (in 2) until you can get it fixed.
  • Trans shifts into gear harshly, car feels sluggish off the line, No 1st, 4th or TCC lockup available, Manual 2nd, 3rd and Reverse are only available gears, CEL is on: Transmission is either in limp-home mode or has lost electrical power. If there are lots of error codes in the PCM, check the under hood fuse that powers the transmission, and if it pops again, look for a short in that circuit like an O2 sensor harness touching exhaust. Otherwise, check PCM codes for a particular fault in the transmission causing the PCM to put it in limp-home mode.
  • No 1st or 4th available; trans shifts 2nd to 3rd by itself in D or OD and locks the converter : Shift A solenoid failed. Easy fix in the pan. Or a wiring problem from PCM to trans.. or PCM.
Check to see if your transmission is in the limp mode, which would only give you 2nd, 3rd and reverse gears. No 1st or 4th gear.
0helpful
1answer

I have a 97 f-250 7.3 with a manual trans. and it wants to jump out of reverse if I dont go to 1st gear and then to rev. first.

Sounds like the shift lever is not coming completely out of 2nd gear. So, by shifting into 1st gear, you recenter the shift lever. You can confirm this by going under the truck and moving the 1st - 2nd lever on the side of the transmission with your hand. If the shifter goes into reverse after you manually recenter the 1-2 lever, then you need to correct the problem that prevents the "normal" recentering of the 1-2 shift lever.

Possibilities are: Bent shift rod; worn shifter; worn shift rod at connection to shift lever on transmission.
1helpful
2answers

WHEN YOU PUT THE CAR IN DRIVE IT WILL NOT GO ANYWHERE

Its the electronic shift control located just under the battery ontop the transmission replace or repair will solve the issue

it'll go into drive but once it reaches 1500 rpm it'll drop into neutral as a safety because at this rpm it is being told to shift gear and when it fails to do so it safely goes into neutral

it will go into reverse just fine and park and you can run all the low drive gears until you reach 1500 rpm then it'll cut it off

i pulled mine out re soldered bad components on the board to fix it but im an electronics engineer it may be easier for you to just replace it
Not finding what you are looking for?

69 views

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...