Where do you plug the check engine scanner?
SOURCE: 2003 Honda Civic -LX Timing belt
I tried to get my timing belt/water pumped changed at 96,000K's and my dealer told me the belt in our 2003 Civic is good for 7 years or 168,000K's. I didn't believe him, so I called another dealer out of town and they told me 7 years or 184,000K's.
SOURCE: Trouble shooting P0420 code, bank 1, OBD II for 2000'?
misfiring can cause a P0420 code.
I would recommend a set of honda plug wires and plugs if the P0420 code returns.
I have used bolt in aftermarket bolt in catalytic converters but don't remember the brand name they fit ok and i have had 1 or 2 return with a P0420 code out of about 20. I have never replaced the oxygen sensor on a civic like yours.
I always fix the misfire problems, reset the computer, and have the customer drive it and see if the code p0420 returns. 50% don't have the P420 code return. drive it and see what happens and go from there.
SOURCE: how to remove the radio in a honda civic 2003
go to an auto parts store and purchase a repair manual it will clearly tell you how to remove the radio . read and understand the directions carefully if you have questions ask the partscarrier they often can assist you
SOURCE: p 1705 code, honda civic lx 2001
Have tranny serviced . Check tranny fluid level fill with HONDA ONLY fluid. If not fixed have fluid drained and filter replaced on tranny
Testimonial: "thanks u very much. the problem has been resolved. very good advice."
SOURCE: 2003 honda civic how to remove door panel
Step one Look at the inside door handle. Behind it you should see a little cover, You pop that off and there will be 2 phillips head screws behind it. remove them.
Pop out the door handle, and unplug the power lock plug,
Youll also have to take the door lock rod, by spinning the plastic door handle 90 degrees until u can wiggle it out.
next remove the sail panel( The little triangle shaped piece in the corner of the door on the top, ( may have a tweeter in it) ( it just pops out)
Next take a screwdriver (flat head) and pry off the cover of the door handle, there will be
2 phillips head screw behind it ( remove screws)
Unplug power window connector (big green plug)
Now just start gently pry the door panel off with a screw driver, see if u can peek behind the panel and see where the panel clips are, and pry near those areas
obd1
1995 and older obd2 1996 and newer. the manual will tell you where the
diagnostic port is exactly. could have 2 one under the steering wheel side of the dash and 1 under the hood. the scaner kits will
usualy tell you what vehicles and what adapter to use. To learn more:obd2 scanner
303 views
Usually answered in minutes!
×