If you don't have one that works for the vehicle now, you'll have to take it to your local dealer to have it programmed to the vehicle. Some will charge for this, some will do it at no charge.
If you do have a remote that is programmed and working for the vehicle, then the following steps will allow you to program another remote:
1. Enter vehicle and close all doors.
2. Put seatbelt on (or clip it into the buckle) to shut the warning buzzer off.
3. Put key in ignition, turn to run position but don't start it.
4. Press and hold the unlock button on the working key fob and hold for 4 seconds, then also press the panic button.
5. Release both buttons and you should hear a single chime to indicate it is in program mode. You have 30 seconds after the chime to program any additional remotes you want to program.
6. Press and release both the unlock and lock buttons simultaneously on the remote you are programming. You should hear another single chime.
7. Within 4 seconds after hearing the chime, press either lock or unlock button on remote that you are programming.
My functional fob (Transmitter) have only two buttons lock and unlock,no panic button.
I have purchased another similar spare fob to programme. How I do this?
Please help and note that both functional and non-functional fobs have no panic button
3,257 views
Usually answered in minutes!
thanks for the mail but my pt cruiser is a year 2000 model which does not have a panic button on it will it work without this?
I have a new key fob, which I bought on ebay for a Chrysler PT cruiser 2005 convertible. It has 3 buttons - i.unlock and disable alarm, ii.lock and enable alarm and iii.open boot (it does not have a panic button as mentioned in one of the solutions)
I need to programm the new fob. I would be grateful for any soltions (not involving an expensive visit to the Chryler dealer).
Many thanks
Thanks - I have 1 original fob however I do not have a panic button:
Mine has 3 buttons -
i.unlock and disable alarm,
ii.lock and enable alarm and
iii.open boot (it does not have a panic button as mentioned in one of the solutions) I need to programm the new fob. I would be grateful for any soltions (not involving an expensive visit to the Chryler dealer). Many thanks
Ive gone to the Dealership and they couldnt reset it . I purchaced a fob at the dealership to play it on the safe side and they just couldnt help.They mentioned that i might need to purchase a $829.00 ECU to boot in order to fixit.
Key stuck in fob
suzuki swift central locking fob key doesnt work
chevrolet equinox alarm when using key and not fob
what does that mean
fob key broke
×