Pulled fuse to turn off
SOURCE: 1998 gmc sierra brake lights
did u check that they not burn?if not you should Check the wires going into the steering column if you don't have separate turn signal lights and brake lights because if they use the same bulb then the turn signal may be bad. If I remember correctly that particular car doesn't work this way, but I include it just in case.
SOURCE: Brake lights do not work
This is a well documented problem, replace the turn signal/multifunction switch to correct this issue, this very problem happened on my GMC, it is a 99 as well, replaced the switch as instructed by a chevy forum member and it fixed the problem
SOURCE: Remove front Brake Rotor
Try opening up the caliper with a flat screwdriver thru the opening in the middle of the housing.pry on the rotor and pull towards you to push the rotor back.That should loosen it up enough for you to get it of the rotor.If that dont work you probably got a stuck caliper and have to release the brake line and do the procedure again. GOOD LUCK
SOURCE: how do you remove the third brake light assembly
You'll have to gently apply some prying pressure to the housing as you turn the screws, it sounds like they've stripped the part they go in...
137 views
Usually answered in minutes!
×