Rubber mount on carrier bearing is shot.. driveshaft goes thru carrier bearing and mounts with two bolts to underside of truck. ( like driveshaft loom) the rubber is destroyed, which makes driveshaft have a lot of slop, which makes loud banging noise... i took out driveshaft. which is 2piece driveshaft. i can not get them pulled apart.. tried heating up with torch and all.. is the carrier bearing a replaceable part on this vehicle. or is it a non-serviceable part, and must need complete new driveshaft assy.. please help.. thanks
It is replaceable
normally it comes complete in the rubber mount
you will have to undo the drive shaft flange at the bearing
remove the drive shaft and take it to an accredited drive shaft repair shop or take the vehicle to an accredited drive line specialist shop
the repair will require that you place the flange back on the shaft after the bearing replacement in exactly the right position or you will get harmonic vibration after the job so talk with the experts first if you want to diy
SOURCE: 1.6 gtd driveshaft weight.
cut it off and dont worry about it.put on a new boot clean greese.you will not notice anything with that off the axel.i have done it many times
SOURCE: 2001 Jeep Wrangler 5spd.... 2wd is out!
Either you have broken something inside the transfer case but equally likely is that you blew up the spider gears in the rear differential. I'd remove the cover and take a look. If they're broken, it won't be difficult to see.(smaller gears inside the center section) And, they are replacable
Hope that's all it is!
Good Luck!!!
SOURCE: 2005 ford escape 3.0l AWD XLT - DRIVESHAFT CARRIER
if there is some one in your area that balances driveshafts they can change just the bearing for you
SOURCE: 99 XJ, front driveshaft, rear set of U-joints.
Buy a can of engine degreaser and spry it on it the let it set for 30 minutes then brush it and clean it. Good luck
To install:
1,299 views
Usually answered in minutes!
×