SOURCE: 91 jimmy starts cold, runs rough hot, dies when put in drive
Try to unplug the mass airflow sensor and start it. It will idle higher but should run fine. If it works then you need a MAF sensor. Be sure you have an OBDII code puller to clear the computer when done
SOURCE: 1997 JIMMY,DRIVING DOWN THE ROAD,GOES DEAD,SIT A BIT,START'S.
When was the last time the fuel filter was chg. If you can't remember its time for a new one.If it does not help after you chg. filter, best to fuel pressure test, to see if pump is going bad.
SOURCE: 98 gmc jimmy will start and then immediately
most likely your fuel pump regulator is bleeding off it is located under the top intake plenum.
SOURCE: 1994 gmc jimmy hesitataes upon acelaration
I would like more info, like what have you done so far. But it could be related to fuel line pressure (needs to over 35 psi), or and over due complete tune-up. If tuneup was done recently then go back over it. The plug wires are not easy to put on and if the little tiny black clip breaks off the wire is junk. If the wires are not on correctly it will cause a misfire. But my first guess would be a tired fuel-pump. let me know if that helps or if you may have other questions.
SOURCE: Truck starts, runs for 5-10 seconds, then dies
take out your mass airflow sensor located on air intake pipe and clean with brake cleaner also is your engine light on?
128 views
Usually answered in minutes!
×