98 land rover discovery belt routing - Discovery Land Rover Cars & Trucks

Check the wires. Sound like a couple could be touching

You will not find anything better than this :

http://www.lrrforums.com/showthread.php?18191-How-To-Change-your-engine-belts

did u check the fuses?? if it ain't the fuses,you have a open ground somewhere.

Telephone: Fax: VAT Registration No.:
Notes Specified value Measured value
Ignition system
Ignition coil Make Bosch
Ignition coil Type 0 221 122 392
Ignition coil supply voltage + with ballast V 11,0
Primary resistance Ohm 0,67-0,82
Firing order 1-8-4-3-6-5-7-2
Distributor (ECM) Make Lucas
Distributor (ECM) No. 42583A
Contact breaker gap/trigger air gap mm 0,20-0,35
Cylinder layout

Manufacturer: Land Rover Model: Discovery (90-98) 3,9 Engine code: Output: 134 (182) 4750 Tuned for: R-Cat Year: 1994-98
© Autodata Limited 2007 14/05/2011 V6.410-

8 7
6 5
4 3
2 1
looking from front of disco

you can google free wiring diagrams for 1998 land rover discovery.they show many different diagrams

The serpentine belt routing diagram for a 1998 Land Rover Discovery 4.0 liters with A/C


CS = Crankshaft
F = Fan pulley
G = Guide pulley
Gen = Alternator
HP = Hydraulic Pump
T = Tensioner
AC = Air Conditioning
PAS = Power Assisted Steering

is this it?

here's you go, hope this help.

remove top of fan cowling 2 clips draw a diagram of belt route put spanner on tensioner pulley bolt turn clockwise remove belt with assistant helping keep tensioner pulled back fit new belt over pulleys release tensioner onto belt refit cover

Remove the fan shroud cover and draw the fan belts route, loosen the aircon tensioner bolts x 3 on the left side of the cover and remove the aircon belt.With a 15 mm socket on a power wrench pull the auto tensioner to the rightand remove the belt , with a little skill and patience you can get the old belt off and the new one on over the fan blades without removing the fan.Make sure the belt is on properly to prevent it coming off when starting.