Rewire sperplug wires truck wont start

firing order is 1,3,4,2 and its clockwise rotation. cylinder 1 is at the front of the motor by the fan blade.

Wow, sorry about that problem.

First, you must resolve the issue that caused the fire. Then, while it IS possible to replace all of the wires, it is TONS easier to get a replacement harness and put that in.

See if your getting spark,If not its probably the crank or cam sensor.

Firing Orders

• Firing Orders

Sending Units And Sensors

Starting System

• HOME /
• REPAIR HELP /
• 1996 CHEVROLET CAVALIER 2.2L SFI OHV 4CYL REPAIR GUIDE /
• ENGINE ELECTRICAL /
• FIRING ORDERS /
• FIRING ORDERS

GM Cavalier/Sunfire 1995-2000 Repair Guide

FIRING ORDERS

Print
See Figures 1 and 2
To avoid confusion, remove and tag the spark plug wires one at a time, for replacement.
If a distributor is not keyed for installation with only one orientation, it could have been removed previously and rewired. The resultant wiring would hold the correct firing order, but could change the relative placement of the plug towers in relation to the engine. For this reason it is imperative that you label all wires before disconnecting any of them. Also, before removal, compare the current wiring with the accompanying illustrations. If the current wiring does not match, make notes to reflect how your engine is wired.

Fig. Fig. 1: 2.2L (VIN 4) Engine Firing Order: 1-3-4-2 Distributorless Ignition System

You need to run a fault code test on the computer control module. To learn how go here. The code lists are there as well.

At least $1500.00 Many hours of labor and that will kill you.

hope this helps double check Firing Orders

To avoid confusion, remove and tag the spark plug wires one at a time, for replacement.

If a distributor is not keyed for installation with only one orientation, it could have been removed previously and rewired. The resultant wiring would hold the correct firing order, but could change the relative placement of the plug towers in relation to the engine. For this reason it is imperative that you label all wires before disconnecting any of them. Also, before removal, compare the current wiring with the accompanying illustrations.

2.2L (VIN 4) EngineFiring Order: 1-3-4-2Distributorless Ignition System
Click to Enlarge

2.3L (VIN D) and 2.4L (VIN T) EnginesFiring Order: 1-3-4-2Distributorless Ignition System

calm down!we can fix anything,so why did you replace the wires to begin with? and do you have or do you need a firing sequence w/ wires?talk to me

check this,
remove a convenient spark plug, stick it on it's wire and place where you can see it, stick you finger over the spark plug hole and have a friend crank the engine, note whether the air blast and spark are the same instant if not the distributor's out of time

check the crank senser i had the same problem changed senser run great