My echo has two belts. Not one, like shown in this diagram. This diagram doesn't work for me, or anyone else that has my belt setup with two belts. One for the AC/Alt, and one for the power steering.
SOURCE: toyota echo serpentine belt
The only way to loosen and tighten the serpentine belt is by loosening the alternator and sliding it back or forward. There are TWO bolts that must be loosened, one above, and one below the alternator pulley. A bit of penetrating oil can make things easier.
SOURCE: how to change serpentine belt on 207 toyota camry
4 cylinder diagram
6 cylinder diagram
Loosen the tensioner pulley to remove the belt. It is the one that has a long bolt running through it. Once you remove the old belt, install the new one using the appropriate diagram from the above two links. Readjust the tension using the bolt you loosened to remove the old belt.
i hope this helps
matthew
SOURCE: Need a serpentine belt diagram for 2004 Toyota
Sorry for the delayed response.
CLICK on the following LINK. It has the Serpentine Belt Diagrams you will need.
If you would: Before Clicking: Let me know if this helped you, or if you have any additional information or questions. Feel Free to contact me at FixYa.com!
Again my apologies...
Thanks.
http://www.2carpros.com/car_repair_information/year/2004/make/toyota/model/corolla/2004_toyota_corolla_drive_belt_routing_diagram.htm
SOURCE: how to remove the serpentine belt of a 2004 toyota
Actually you don't have to do all of that. I just replaced one from the top. On the passenger side of the engine where the belt is, you will see the tensioner in the middle. Using a larger breaker bar with the socket that fits the bolt in the middle of the wheel, force the tensioner toward
the front of the car to release pressure to remove the belt. I think it was a 15mm but can't remember for sure. I do know they are all metric sizes on that engine. The tricky part is to remember how the belt is routed. If you forget, see the diagram below. There isn't much room to work, but I'm proof that it is possible. When putting the new best on, route all pulleys and leave the alternator for last since it's right on top and easy to get to. Good luck and be patient. It's doable.
SOURCE: 2000 toyota echo timing belt replacement
Hi. Toyota echo uses a chain drive cam. No timing belt
1,042 views
Usually answered in minutes!
×