SOURCE: Location of oil filter on 2007 Toyota Solara Convertible
The oil filter is located under the exhaust manifold in the front of the engine on top near the radiator loosens. It can be removed by turning to the left tightens the opposite.
Good Luck
SOURCE: oil filter
HI, The oil filter is a canister type filter on the top of the engine. You need to pop off the engine cover and you will see the filter cap in the front of the engine. To take it off I would suggest using the special Mercedes filter removal tool. If this is not an option you could use large pliers. Just be careful as this cap is plastic.
SOURCE: Canno locate the oil filter on a 2007 Jetta 2.5
remove plastic wind plate under engine. It looks like a black plastic **** with a hex or octogon shaped nipple . the whole **** lookin thing come off. it will be full of oil and be messy. I wear rubber gloves .
SOURCE: Location of cabin air filter
Remove drivers side underdash sound proofing panel, remove accelerator pedal(yeah I know). Fold carpet back remove three retaining screws from cover, fold cover up. remove filter by moving it out behind brake pedal.
SOURCE: How do I replace the bi-xenon bulb in my 2007
I just did this on my 2008 C70, which I believe uses the same type of bulb. It's very easy. By the time you do your second one, you can probably do it in less than 5 minuites.
1) Take careful note of the orientation of the headlight houseing retaining pin, HID transformer, and bulb retention device.
2) Refer to the owners manual to pull the headlight housing retaining pin.
3) Pull the headlight housing forward until you can access the wiring harness plug. Push the clip on the top of the plug to unlock, then remove the plug.
4) At this poing the entire headlight housing is detached from the car. Take it indoors and have a beer before the next step.
5) Push back the two spring clips and remove the access door from the back of the headlight housing.
6) At this point in the owners manual, the instructions tell you to refer the problem to an expert and do not provide further details. Shoot you got the darn thing out. And you have a beer in hand. You look like an expert. Let's continue.....
7) The low beam light has a transforer attached to the back of the bulb. Unplug the wires attached to the transformer.
7) Twist the transformer counter clockwise 1/8 turn, and remove the transformer.
8) The base of the bulb is now visiable, but the bulb is held in by a large retaining knurled plastic knob about 1-3/4 inch in diameter. Twiist that knob 1/8 inch turn counter clockwise and remove.
9) The old bulb is now free, and can be removed. Do not touch the glass on the new bulb, but carefully seat it in the same orientation in the housing.
10) Assembly is a reverse of the previous steps. Hopefully you paid attention to the orientation during removal, as the bulb, retaining knob, transformer, and housing retaining pin all are keyed and will fit in one way only.
11) Have another beer, and bask in the admiration of your family and friends, you expert you! Congratulations!
253 views
Usually answered in minutes!
×