I have 11 ABS codes stored. Code 35, 41, 42, 43, 44, 45, 46, 53, 61, 62, 63. I think maybe it's just 1 or 2 abs sensors that is causing all these codes. I checked the rear speed sensor's resistance, should be 1.0Kohms-1.6kohms. No resistance measured (nothing). Then i checked the front left & right speed sensors resistance and they too do not have any resistance. The front's should have 2.0kohms- 2.8kohms if i'm correct. If there is no resistance then those sensors are bad right? Is there any possible chance that all three abs sensors have gone bad & causing all these abs codes? Can anybody help me
SOURCE: ABS Light is still on, even after I replaced the sensor
it can store one code or all codes at a time.disconnect the battery for 5 min.this will clear the memory.after reconnecting the battery if the abs light comes back on when driving then there is another problem.most times it is either the sensor or the wiring.
SOURCE: abs light comes on after driving about 1 mile
You need to check the sections on the abs ring for damage and rust contamination. Thoroughly clean the ring and gaps to make sure tha sensor is getting the correct count per revolution. Also check for play in the bearing which can cause a fluctuation in readings, especialyy if really loose.
Cheers John
SOURCE: ABS pump failure
did you disconnect your engine battery and wait a couple of minutes to reboot computer so it can recognize any new hard ware in stalled??hope this helps
SOURCE: ABS indicator stays on after changing battery - 2005 Honda Accord
Try unhooking your negative battery cable for about a minute. And the re-inslalling it. If that doesn't reset it , it was probably just a coincidence that the battery amd the speed sensor went bad at the same time.
SOURCE: the ABS light of my Honda Accord 1993 is always on,
Hello tctran.
Although the one sensor you measured resistance on is a bit low, you didn't list the rear sensors. In my experience with the Hondas the rear sensors seem more common for failure.
Also see quite a few problems with cracked sensor rings on the drive axles.
Check harness connections for signs of water intrusion and corrosion as the voltage created by these sensors is very low and any additional voltage loss is critical to the operation of the system.
I hope this helps with your diagnosis.
If you have any further comments or questions leave them in comments and I will respond.
KL
Testimonial: "Thanks. I will check the rear wheel sensors."
ABS LIGHT AND MODULE TROUBLESHOOTING:
Anti
lock brake system light comes up when there is issue with car brake systems. It
can be low brake fluid or faulty ABS fuse or its issue with brake system or assembly.
Your vehicles brake system needs inspection.
To
troubleshoot these issues, I suggest you to refer the help links provided below.
There are direct links with accurate solution, for these specific issues.
Click
the link below and follow the procedure: ------
http://howtobyme.blogspot.com/2011/11/abs-and-service-light-comes-on.html
-------------------
http://howtobyme.blogspot.com/2011/11/abs-light-stays-on-but-brakes-work-fine.html
----------------
-------------
http://schematicsdiagram.blogspot.com/2011/06/abs-and-traction-control-lights-stays.html
-------------
http://howtobyme.blogspot.com/2011/11/abs-brake-lights-warning-indicator.html
-----------------------
http://whoisbyme.blogspot.in/2012/07/battery-light-and-abs-light-on-dash.html
-------------
-----------
http://technoanswers.blogspot.com/2011/11/how-anti-lock-brakes-work.html
-------------
http://technoanswers.blogspot.com/2011/11/brake-system-troubleshooting.html
-------------
http://technoanswers.blogspot.com/2012/01/anti-lock-brake-light-stays-on-all-time.html
-------------------
ABS
light comes on and Car makes Grinding noise?
http://repairhelpcenter.blogspot.com/2012/01/abs-light-comes-on-and-car-makes.html
---------------
http://repairhelpcenter.blogspot.com/2011/11/abs-trouble-codes-for-all-1994-00-acura.html
------------
http://technoanswers.blogspot.in/2012/05/2008-toyota-highlander-abs-warning.html
--------------
http://technoanswers.blogspot.in/2012/04/2003-lexus-es-vsc-trac-off-abs-lights.html
----------------
http://technoanswers.blogspot.in/2012/04/2008-toyota-highlander-hybrid-warning.html
-------------
http://schematicsdiagram.blogspot.com/2011/12/abs-brake-warning-lights-remains-steady.html
------------
http://schematicsdiagram.blogspot.in/2012/02/can-i-drive-car-without-abs-fuse.html
-----------
http://schematicsdiagram.blogspot.com/2011/12/where-is-abstcs-module-located-on-2005.html
------------------
http://schematicsdiagram.blogspot.com/2012/01/abs-motor-keeps-running.html
------------
http://howtobyme.blogspot.com/2011/12/when-car-stopsabs-pump-turns-on.html
-----------
http://technoanswers.blogspot.in/2012/02/replacing-abs-unit-on-buick-century.html
----------------
--------------
http://technoanswers.blogspot.in/2012/04/toyota-camry-premature-abs-actuation.html
-----------
How to replace ABS Modulator Control
Unit on Acura Integra?
http://repairhelpcenter.blogspot.in/2011/11/how-to-replace-abs-modulator-control.html
----------------
How to replace ABS Pump Assembly on
Acura Integra?
http://repairhelpcenter.blogspot.in/2011/11/how-to-replace-abs-pump-assembly-on.html
-----------
How to remove ABS Accumulator on
Acura Integra?
http://repairhelpcenter.blogspot.in/2011/11/how-to-remove-abs-accumulator-on-acura.html
---------
How to remove ABS Control Unit on
Acura Integra?
http://repairhelpcenter.blogspot.in/2011/11/how-to-remove-abs-control-unit-on-acura.html
------------
These details will help.
Thanks.
241 views
Usually answered in minutes!
Hello There... where actually you can see the error code numbers? I got OBD II reader but it does not present the numbers. How to access those numbers? My ABS light is ON all the time. Please email [email protected]
Thank you Josef
Is there any physical damage to any of the cables? The front sensor wires in particular are prone to rubbing against the axle boot/steering components/anything inconvenient. The slightest damage will likely trigger the light, since the ABS is VERY sensitive to any changes in resistance.
Also, I believe there was an ABS recall for this model of Passport. Something about the algorithms the computer used to adjust the system. I don't know if it would make a difference but it's well worth a shot.
×