After putting the correct preasure on the tire and resetting the tire preasure light it's still on

This is your automatic tire preasure system.Check your tiere pressures.

Must be something new. I have never reset low tire pressure. The recommended tire pressure for the vehicle with the correct size tires that came on the vehicle should be in the car manual and posted on the vehicle inside the door jams usually.

After checking air pressure and adding air if needed, hold the RESET button in 10-20 seconds and it should clear the Check Tire Pressure light.

PUT IN CORRECT AIR TIRE PRESSURE.YOU CAN DRIVE VECHICLE 25 MILES PER HOUR FOR 2 MINUTES ON A LONG BACK ROAD.THE TPMS SENSOR WILL AUTOMATICALLY RESET.AND THE CHECK AIR PRESSURE LIGHT WILL TURN OFF.

Oh my!!! the dealership forgot to tell you when you bought the vehicle that you needed to rotate the air in the tires every 5,000 miles. just kiddin. I think that you can reset that per the instructions in the owners manual.

Have you reset the sensor? Instructions should be in the owners manual.

THE LIGHT CAME ON BECUASE, IF U OPEN UP THE DRIVER SIDE DOOR, ON THE SIDE SHOULD BE THE SUGGESTED AIR AMOUNT FOR THE TIRES THAT NORMAL COME WITH THE CAR. THE RIMS YOU PUT ON, I GARUNTEE ARE PROBABLY LIKE TWO TO THREE SIZES BIGGER. SO THAT SENOSR IS SENSEING SOME THING IS WRONG. CAUSING THE LIGHT TO COME ON.

pump tyres to correct preasure. press and hold the tyre preasure button for a few seconds (I think the button is near the ashtray)

IF THE PREASURE IS OK AND IT SHOWS ALL 4 WHEELS PREASURE, LIGHT WILL TURN OFF ONES YOU TAKE SOME 15 KM DRIVING.
IF ONE WHEEL IS NOT DISPLAYED, VALVE ON WHEEL IS DEFECT.
MARKO

1. turn the ifnition to ACC or ON and turn the radio off
2. press and hold the DISP button on the radio for at least five seconds until SETTINGS is displayed
3. press the SEEK up or down arrow to scroll through the main menu
4. Scroll until TIRE MON appears on the display
5.press the PREV or NEXT button to enter the submenu. RESET will be displayed.
6. press the DISP button to reset. A chime will be heard to verify the new setting and DONE will be displayed for one second.
7.Once the monitor has been reset, scroll until EXIT appears on the display
8.Press the DISP button to exit programming. A chime will be heard to verify exit.
The system completes the calibration process during driving
This only works if you have a RDS system on the radio.