Question about 2007 BMW M6 Convertible

Open Question

Servotronic malfunction What is this , what is the cause, and how do you repair. Thanks

Posted by on

  • Thomas Wearing Jan 04, 2012

    What is Servotronic Malfunction

×

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Air ride issue


Two completely separate and unrelated systems. I would have to say it would be impossible for the EAS height range to cause enough incline to overwork your fuel pump. Now if you were driving uphill for 5 months non-stop then i would say possible. A 2004 would be due for its first fuel pump replacement in my estimation. Around 80k miles would be about right.

Jul 18, 2013 | 2004 Land Rover Range Rover

1 Answer

2004 explorer goes into engine failsafe mode when it shifts from 1st to 2nd. Engine still seems to idle ok, shift fine and run good but has reduced power. Tool light, abs light and service engine light...


No way to guess at this symptom,too many possible causes.You will need to have the diagnostic codes retrieved from the computer by a repair shop or a parts store.When I have that information I would be happy to make a recomendation as to a repair.Thanks!

Apr 02, 2011 | 2004 Ford Explorer

1 Answer

Will a bad knock sensor cause a misfire. car is missing change the plugs no help codes are misfire and knock senser sometimes a #2 o2 sensor. 1999 maxima thanks for your help.


A Bad Knock Sensor will not cause a misfire, unless the advance is off due to a faulty Knock Sensor. The O2 Sensor will cause a random misfire.

Good luck on this repair.

Jan 21, 2011 | 1996 Nissan Maxima

1 Answer

My front wheel keeps migrating to the back of the wheel well what causes this


A-frame bushings have failed. Get a front end inspection and have them itemize the repairs and show you the worn out parts. If you like, we can provide advice on the cost and appropriateness of repairs. Thanks for using FixYa.

Jan 08, 2011 | 1996 Dodge Caravan

1 Answer

My 2004 tahoe speedometer stop working along with gas gage why is this


This is commonly caused by failing gauge motors on the circuit board of the instrument cluster. It is repairable though, check this page for more on it - Tahoe Speedometer Repair

Thanks,
-Dr

Jan 06, 2011 | Chevrolet Tahoe Cars & Trucks

1 Answer

95 ford escort transmission leak


Dont waste your time and money trying to use a transmission stop leak product, they don't work on large leaks, you say the leak is excessive in this case the you must remove the transmission to access and remove the torque converter, after you have removed the torque converter carefully inspect the torque convert imput shaft for wear and also you will need to visually inspect the transmission front pump bushing for wear also, I have seen it all to often people just replace the seal thinking it was just a seal failure, well more times than not there is a reason for seal more than just the age of the seal, excessive wear on trans pump bushing and torque converter imput shaft is usaully the cause, check and repair those as good practice during this repair unless you just like to do the repair over again for free... also check the torque converter run out, sometime when they are repaired they are welded back together somewhat crooked which will cause it to spin off of a true center, this will cause immediate damage to transmission. Check also your engines crankshaft end play for looseness this can cause wobble which will transfer to transmission causing this problem as well... do the repair thouroughly and who ever does it for you have them check all that I listed and you should get a good repair which will last without issues.... please rate my help thanks...

Aug 08, 2009 | 1998 Ford Escort

1 Answer

The garage has given me repair codes and I'm not sure what they are for I know the gearbox is faulty. The codes are PO734 PO732. Thanks The Model is a Trajet which is not in your options.


P0732-GEAR 2 INCORRECT RATIO
PROBABLE CAUSE-WIRING,TR SENSOR,SHIFT SOLENOIDS,MECHANICAL FAULT.
P0731-GEAR 4 INCORRECT RATIO
PROBABLE CAUSE-AS ABOVE

Jul 06, 2009 | Hyundai Santa Fe Cars & Trucks

Not finding what you are looking for?
2007 BMW M6 Convertible Logo

Related Topics:

387 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

stephen Kiarie
stephen Kiarie

Level 1 Expert

32 Answers

vince

Level 3 Expert

1234 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1175 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...