Cars & Trucks Logo

Related Topics:

shawn carter Posted on Jun 06, 2017

I have a 88 f250 with a 351 winser truck has been setting for 3 years when i turn the key on fuel pump wont kick on or pressure pump wont or the injectors i have changed both relay checked all the ground still the same i know the pumps are working used a jumper wire and both pumps kick on the tank pump and the presure pump but the injectors wont its killing me cant figure it out and the truck will run spreyed starter fluid in the intake and it firerd up please help please!

5 Related Answers

Anonymous

  • 112 Answers
  • Posted on May 24, 2009

SOURCE: cant figure out why it wont turn over changed the fuel pump checked all the fuses and relays i could find

it can be that the timing might be off . . if it turns over but wont start that can be the problem also check if u are getting spark

Ad
michael_grey

Michael Grey

  • 365 Answers
  • Posted on Jul 21, 2009

SOURCE: 1989 f150 300 inline 6

I would check the stator(hall effect switch) in the distibutor.4f600f4.jpg

emissionwiz

Marvin

  • 85242 Answers
  • Posted on Jul 27, 2009

SOURCE: 1991 ford f-150 fuel pump will not come on

remember the switch only gets power for 1 second when u turn the key on, the common problem is the ignition starter switch comes apart, it is located at top of the steering column near the bottom, drop the column down (2 nuts) and inspect the switch for separation.

Anonymous

  • 784 Answers
  • Posted on Oct 14, 2009

SOURCE: 91 ford ranger...fuel pump will not run pump is good

It won't hurt to jump sire to drive, It is designed to pump all time when the engine is running. The only problem is the pump should not be on if engine is not running since it is designed that way to prevent a fire while pump continues on once engine is stops in a car accident. There is a control device to immobilize the fuel pump, if there is no speed sensor signal from the crankshaft. This needs to be located and fixed.

Anonymous

  • 7 Answers
  • Posted on Jan 29, 2010

SOURCE: 94 ford Tarus ,,had fuel problem,,replaced fuel

Fuel shut off switch should be located in the trunk on the same side you fill your tank on. The switch is guarder and you will have to figure out which way to press it

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2005 pt cruiser wont start replaced fuel pump, is getting spark,and turns over. yet wont start help

Do you have a check engine light, what is the code. Do You have fuel pressure. You changed the fuel pump but is your fuse and relay good to the fuel pump. When you turn the key on do you hear the fuel pump kick on. It should come on as soon as you turn the key on, not just when you try to crank it. If you have a code it would help.
0helpful
1answer

Fuel pump

The pump relay provides power for 3 seconds when you turn the key switch on. Then the computer has to see oil pressure or RPM to continue powering the pump.
0helpful
1answer

Turns over but wont start

IS IT GETTING SPARK ? IS THERE FUEL PRESSURE ? WHEN YOO TURN THE KEY YOU SHOULD HEAR THE FUEL PUMP KICK IN OR MAKE A HUMMING SOUND , IF YOU DONT, YOU MORE THAN LIKELY NEED A FUEL PUMP.
0helpful
1answer

1996 olds 88 3.8 engine starts up runs about 15 minutes then shut down.Wait a while and will do same cycle over. I replace fuel pump, filter tank clean. No codes, engine runs find until it stops getting...

There is a fuel pump prime cycle (2 or 3 seconds)when you turn the key to on and once you start the engine the fuel pump power comes though the oil pressure switch.No oil pressure,no power to the pump.maybe your oil pressure switch has become weak?I would use a scan tool and command the fuel pump on when it does shut off,just to make sure the pump can run,as it could be a bad pump too.Also when it does quit,if you turn the key off for 10 seconds, you should get a prime cycle by turning the key to on.Have someone listen at the gas tank for a fuel pump noise,which will be only 2 or 3 seconds,but will do as a pump running check.Next would be to check for power at the back at or near the fuel pump,power and no pump.replace pump.No power to pump,follow power back to the front through oil pressure switch and fuel pump relay etc.You can always add your own power to the pump from a power source the switches off with the key if needed bypassing the existing wiring and oil pressure switch.
0helpful
1answer

88 fiero starts on it own, but wont stay running.

the brain is not sending the proper fuel pressure codes to the fuel rail to evenly distribute the fuel to the intake and fuel rail.
perform a fuel pressure test check on it ok? also run a diagnostic scan on it and see what codes come out.
0helpful
1answer

88 190E has been sitting for over a year, wont start. Have cleaned out the fuel, still wont start. An amituir mechanic said it needed a fuel pump and or a fuel relay. (Very costly) Any advice? The car ran...

what is the fuel pressure reading, bet it's zero. replace the fuel pump and the fuel filter. when fuel gets old it gums up the pump and it won't spin and produce pressure, very common complaint on stored cars, i.e. no fuel pressure.
0helpful
1answer

My 1993 Olds 88 wont start cranks but wont kick over. Fuel prob

3.8 are known for ignition trouble but first use the fuel release valve located on top of engine under a screw cap to see if your getting fuel. It takes 4 things to make engine run fuel spark air and compression. But most likely the Ign control module or crank sensor. So try this
1) check the fuel pressure
2) check for spark
3) compression test

0helpful
1answer

88 camaro wont start

Hi
Turn key on a listen for fuel pump running in tank. The fuel pump should run for 3 to 4 seconds and kick out. If not running try tapping bottom of tank with a soft hammer and fuel pump might start working but if this is the problem it will have to be replaced.
0helpful
1answer

1994 f250 shutting off

sounds like control module or fuel pressure regulator
1helpful
3answers

Starts but wont stay running

In reply: if its not the maf there are 2 relays in the relay box i belive its underhood, 1 primes the fuelline to 32psi the second kicks in after it starts, and keeps it running and varies the psi. if the primer relay isnt kicking in then it wont start due to no fuel

THX

Don :)
Not finding what you are looking for?

145 views

Ask a Question

Usually answered in minutes!

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...