SOURCE: Remote car door opener got wet and won't work
Well first open it up completly. Remove the battery. Get a hair dryer and dry it out completly. Then let it stand for several hours to cool down. Make sure that the contacts where the battery fits are clean of any rust, or corrosion. Now install a new battery. It should work.
SOURCE: programing keyless entry
If you have an owners manual the programming instructions are in there. If no manual here they are:
1. Turn the ignition off.
2. Ground the receiver program terminal. Jump the two terminals located in the programing ground connector. (What this means in simple terms is locate the wires that run on the right side of the trunk. There is two black wires that has a plug on the end with two prongs. It is in between the antenna and tail lights.)
3. Within 2 seconds of connecting the prongs the door locks will lock. The unlock and the rear compartment lid release will produce a cycle, causing the horn to chirp. This indicates that the module is ready for reprogramming.
4. Press and hold the lock and unlock buttons at the same time until the doors lock and unlock. The rear compartment lid will release and the horn sounds to indicate that the transmitter has successfully been reprogrammed. (Hold buttons down for approximately 12 seconds)
5. Repeat the previous step for the remaining transmitters.
6. Remove the jumper at the program connector.
7. Verify the proper operation of each transmitter
SOURCE: 1995 jaguar xj6 dead battery and can't open trunk. please help,
you will need to use a jump box to put 12 volts to the engine compartment fuse box .Then you can
open trunk with key bob or button in car.
SOURCE: keyless entry wont work after battery died
stand at the vehicle and push and hold the lock and unlock buttons till the horn chirps to resync the key fob
SOURCE: lost keyless entry remote
turn door lock left twice to un do alarm ,on old cars it may or may not work due to old age
261 views
Usually answered in minutes!
×