SOURCE: How do I reset the VSA on my Honda Odyssey EX-L
i think reset the millage and hold the millage reset button while off and turn the key on
SOURCE: my 2006 honda odyssey won't start...2 days ago I
it sounds like that, if after installing the battery, it ran and started good, then this tells me it run until it drained the battery, so this tells me theres a charging problem, make sure the belt is on and then take a good look at the alternator and battery connections,then check the alternator output to see if its charging, it should put out 13.5 to 14.5 volts with engine running, if it doesnt then replace battery,you can also check for power at the alternator and other tests but i dont want to confuse you, a good thing to do is when removed just to double check have the parts store test it for you, it sounds like a bad alternator, hope this is helpful, good luck.
SOURCE: 2003 Honda Odyssey Brake light replacement
open the rear hatch. Between the tail light housing and the rear hatch opening there is a trim strip with two flush fitted flap doors. Insert a small straight blade screwdriver into the small slot on the tail light side of the flap. Pry gently inboard and the small flap will open (the hinge side of the flap is on the side of the rear hatch opening.) Now you can remove the screws that hold the tail lamp assembly in place. Finally, there is still a "spear point" clip that fits into a socket near the front outboard corner of the assembly. Gently pry with a tape wrapped screwdriver (avoids scratches) and force the assembly straight back. The clip should release and free the assembly so you can change the bulb(s).
SOURCE: My Honda Element 2008 has a VSA Warning light and
It may be as simple as your oil condition or oil level. If you have poor oil in your engine the VTEC system will not operate properly and when RPMs reach 2800 or so it will buck. If everything checks okay with the oil have the code checked for your check engine light/VSA light.
SOURCE: brand new 2010 Honda odyssey Touring within 40
I can’t be much help on this one (too new for my experience), but your manual will say this (which probably isn’t all that helpful either).
The vehicle stability assist (VSA) system helps to stabilize the vehicle during cornering if the vehicle turns more or less than desired. It also assists you in maintaining traction while accelerating on loose or slippery road surfaces. It does this by regulating the engine’s output and by selectively applying the brakes.
When VSA activates, you may notice that the engine does not respond to the accelerator in the same way it does at other times. There may also be some noise from the VSA hydraulic system. You will also see the VSA activation indicator blink.
The VSA system cannot enhance the vehicle’s driving stability in all situations and does not control your vehicle’s entire braking system. It is still your responsibility to drive and corner at reasonable speeds and to leave a sufficient margin of safety.
On touring models you will also see a ‘‘CHECK VSA SYSTEM’’ message on the multiinformation display if there is a problem with the VSA system.
Without VSA, your vehicle still has normal braking and cornering ability, but it does not have VSA traction and stability enhancement.
The VSA system automatically turns on every time you start the engine, even if you turned it off the last time you drove the vehicle.
I’d get on the Honda people about the problem, especially since you just got the car. I would think that the alarming sounds you are hearing have to do with the unit working the brakes when it shouldn't be, but that's a guess.
Hope this helps some.
3,295 views
Usually answered in minutes!
×