Will 1999 subaru engine fit in 1997 subaru legacy?

the biggest draw back that you will have to check first is the ratio of the diffs you want to change. If they are not the same but will fit then you will destroy the 3rd diff in the transmission from excessive use.

Hi
The engine produce little oil steam when is at normal temperature, this is normal.
This steam goes to the air cleaner for recycling.
Now, the reasons to see oil dripping from the air cleaner are:
Engine oil overfilled, or engine breather valve( if fitted) faulty, or the piston rings causing the pressure to scape into the oil sump ( this means engine damage).
get a technician to chem it.
good luck.

No. The Monroe strut listings say that strut does not fit a 99 Legacy.
.

Hi, quickest way to answer your question. Contact a major salvage yard. They have cross-reference master lists for most vehicles as to what will fit what or, can be swapped over.

Let me know if you were successful.

Best bet on this inquiry is to go to a local salvage yard. A lot of them possess a interchange listing on parts from different years / models.

Good luck!

you need to remove door panel to unplug miroor connection

replace the coolant temperature sensor (2 pins)... im not sure but i think is brown...

These cars are very hard to find parts for and most of them don't interchange .

Yes you can do this, most cars have one wiring harness for all models, so the connectors are most likely already there, but you will need a fair amount of electrical knowledge to pull this off.

Yes, the block is the same if you are putting in a SOHC.