How to remove front bumper on 2001a dodge ram?

On a 2013 Dodge Avenger SXT, the horns are located in the front of the vehicle, behind the front bumper. There are two horns, a high-pitched horn and a low-pitched horn, that are typically mounted on a bracket behind the front grille or bumper cover.
To access the horns, you may need to remove the front bumper or grille, depending on the specific model and configuration of your Avenger. If you're unsure about how to access or replace the horns on your vehicle, consult the manufacturer's instructions or seek assistance from a qualified mechanic or automotive technician.

Jyst ask a partstore or truckshop...its that easy

Follow the link https://www.justanswer.com/dodge/2i57t-p-how-remove-front-bumper-99-dodge-ram-p.html

REMOVAL Hope this helps?
Labor Operations: Click to display a list of Labor Operations associated with this procedure

1. Mark fender location.


2. Remove wheel if necessary.


3. Remove wheel liner.
   
   
   
4. Remove front fascia as necessary, (Refer to 13 - Frame and Bumpers/Bumpers/FASCIA, Front - Removal) .
   
   
   
5. Remove front lower mounting bolts.


6. Loosen rocker panel cover as necessary.


7. Remove rear lower mounting bolts.
   
   
   
8. Remove upper fender mounting bolts.


9. Remove fender from vehicle.

https://www.youtube.com/watch?v=BCaZGTz1WLw

Not the specific video for your vehicle but this can assist you in the general methods and procedures in replacing a front bumper cover.

Okay...I am completely replacing front bumper parts on my '05 Durango. bumper installed (check), energy absorber installed (check), plastic bumper cover.... lol can't seem to get that on/over absorber...any ideas on how to go about this?

on your rear bumper or just above it there should be an access hole that you can stick the jack handles through ,then you should be able to lower the tire, its like a winch unwinding

my horn fuse keeps blowing and I cant find the horn either!
Can you tell me where you found it?

There are 3 bolts that have to be removed and 2 screws. You need a long extension to get to the one bolt that is near the outer fender. It is hard to see this bolt. To get the other 2 bolts, press down on the front bumper plastics so you have room to get to them. The 2 screws are easy to get to and along the seam between the hood and the light assembly. These 2 screws simply hold the rubber flap that is along the seam in place.

There are 3 bolts two which are located on front of the lamp housing and one more which is located under the lamp housing (if looking at the left side it is above the front bumper trim the space between the two), then remove the two plastic screws for the lamp housing gasket. When you have removed all hardware then pull hard on the head lamp you will have to pull pretty hard then it will pop out your new bulb will be a 9007.