There are no wires you can touch to program key fob's , Dealer only ! Need a factory scan tool !
This procedure will erase all keyless entry transmitters from memory.
Install a scan tool.
Turn ON the ignition with the engine OFF.
With the scan tool, select Body.
Select Remote Control Door Lock Receiver (RCDLR).
Select Module Setup.
Select Program Key Fobs.
Select Invalidate All.
Follow the scan tool on screen instructions.
SOURCE: programing keyless entry
If you have an owners manual the programming instructions are in there. If no manual here they are:
1. Turn the ignition off.
2. Ground the receiver program terminal. Jump the two terminals located in the programing ground connector. (What this means in simple terms is locate the wires that run on the right side of the trunk. There is two black wires that has a plug on the end with two prongs. It is in between the antenna and tail lights.)
3. Within 2 seconds of connecting the prongs the door locks will lock. The unlock and the rear compartment lid release will produce a cycle, causing the horn to chirp. This indicates that the module is ready for reprogramming.
4. Press and hold the lock and unlock buttons at the same time until the doors lock and unlock. The rear compartment lid will release and the horn sounds to indicate that the transmitter has successfully been reprogrammed. (Hold buttons down for approximately 12 seconds)
5. Repeat the previous step for the remaining transmitters.
6. Remove the jumper at the program connector.
7. Verify the proper operation of each transmitter
SOURCE: Horn alarm randomly beeps
Make sure to check all doors, the trunk latch, and the hood to ensure that they are shut. I have looked up your 2006 Chevy Malibu and there has been a lot of people complaining about the alarm system and it going off. There is a TBS (Technical Service Bulletin) out for your car. The TBS says that the Faulty Door Sensor. Take it to your local dealership and tell him what I found for you and they should get you a quote on how much it would cost to repair it.
Thank you for using Fix Ya!
Good Luck!
Any questions don't hesitate to ask me.
Don't forget to rate the overall satisfaction of this solution.
SOURCE: 04 Malibu power locks up and down all the time, even w/key off.
The remote control door lock reciever controls the door locks, and tire pressure monitor. If your TPM and remote work normaly then it will not be the RCDLR. The body mudule is involved but I don't see this problem being related to it. About a week ago I had a car like yours with a small short in a door causing this exact issue. You need to get it scaned for body codes to give you a better idea where to go. Let me know if you need moer help. I have looked on the GM service web site and there are no known issues related to this. Good Luck.
SOURCE: wiring diagram
try this link
http://64.85.6.121/diagrams/printpage.asp?ModelID=17081&MakeID=54
SOURCE: program a keyless entry remote on a 2000 chevy
PROGRAMMING
Method One
Sit in driver's seat
Close all doors
Press and HOLD UNLOCK button on door lock switch.
Insert and remove ignition key twice. Do NOT turn ignition switch
Insert ignition key a third time and leave it in the ignition switch. Do NOT turn ignition switch
Release door lock switch.
A chime will sound three times indicating remote programming active
Press and HOLD the LOCK and UNLOCK buttons on each remote for 5 seconds
A chime will sound twice for each remote: indicating successful programming
Remove the key from the ignition switch to exit programming
Method Two
Remotes can be programmed using diagnostic equipment.
197 views
Usually answered in minutes!
i have 2007 chevy malibu i am trying to program the keyless entry remote you already sent me the instructions on how to do it but i am not seeing the cables that you are talking about and when and if i find these wires do i touch them together to start the process ??
thanks
I have the instructions but no car to try them on, sorry
×