1999 Chevy Blazer windshield wiper problems

Marvin

• 85242 Answers
• Posted on Oct 19, 2008

SOURCE: Windshield Wiper Arm

Pull up on the wiper arm, you will see a tiny little blade on the side of the wiper arm where it goes over the post, take a little screwdriver and pry that out board, this will release the arm from the post, it will be tight, wiggle the arm and pull straight out away from the post.

SOURCE: Windshield wipers were frozen to

you need to replace the inside arm.I did the same to my car . check under the hood to see if it moves likely stripped .

SOURCE: windshield wiper doesnt work

hii..ya u have to replace it with the new
one.Since it is frozen u can't do anything
with that.once u replace it with the new one
it will start working.Other than replacing the
wiper u have nothing to do.
thank u..

SOURCE: my driver side windshield wiper

The wipers on our 2005 Impala would also park in the vertical position. I was perplexed b/c the tab on the wiper motor mounting bracket was not bent down out of alignment. As it turned out, I was simply able to lubricate the spring loaded arm mechanism (in this case on top of the wiper motor/transmission), and this corrected the problem.

SOURCE: wheres the circuit board for a windshield wiper

Hello jlwhelchel: My name is Roger and I will answer your question. Raise the hood locate the wiper motor. Remove the cover held on by three screws. Remove the cover. The cover is the module.
Should you need further help please just ask. Please rate the answer. This way I know the information was helpful. Thank You for using Fix Ya. Roger