How do I replace the passenger side headlight (lowbeam) on a 2008 Subaru Tribeca?

ALL ELSE WORKS
CAR DRIVES?, HEATER AND A/C WORKS OK?

There is a switch that controls both drivers and passenger heaters. One might be off.

Radio volume control on 2008 Subaru Tribeca does not ...

www.fixya.com/.../t25735073-radio_volume_control_2008_subaru_trib...

Jun 7, 2015 - Radio volume control on 2008 Subaru Tribeca does not work, but remote volume control on steering wheel works. ... does not... Replace the volume control(rheostat) inside the radio. .... Oct 09, 2014 ' 2007 Subaru B9 Tribeca.

Chlorine in factory coolant has caused corrosion and damaged the heater core (there was a recall on this WWY-09 which my subaru dealer denied!) flushing wont help. Heater core needs to be replaced.

Get this manual online at www.reliable-store.com and get complete guide on whether to repair or not, service it, and how to repair etc, along with wiring diagrams, electrical diagrams, torque specs, error codes,
everything.

The High and low beams are all in the same bulb. You have to reach in behind the light in the engine compartment and undo the retaining collar and pull it out and then pull the bulb assembly out if it separates from the collar. Unplug the bulb and replace it. I usually stop at Walmart and use the little box they have there to find the proper bulb for the vehicle, in most cases they are the less costly of the places you can get the bulbs.

Try taking off the headlights and remove the bulbs. When you remove the bulbs, there is a gasket. If there is moisture, you will notice that the outside and inside of the gasket is wet. Use a hair dryer and silicone sealant to seal the gasket and the moisture problem shall go away.

I just spent five hours replacing the passenger side bulb because I did not know to leave the spring alone. I then replaced the bulb and when I went to check the headlight, the drivers side blew out. 5 minutes job turned into five hours.

Inspect/Replace There can be slight variations in procedure from one model to another when replacing headlights. For instance, on some models the turn signal light assembly must be removed before the headlight can be replaced. Overall, however, the procedure does not differ much from the following typical instructions.
Make sure the replacement bulb is the same type and part number as the one that is being replaced.
Comparing the old and ther replacement headlamps. To Replace:

• Remove the headlight bezel retaining screws. Remove the bezel. If necessary, disconnect the turn signal lamp wires.
• Remove the retaining ring screws from one or both lights.
• Remove the retaining rings.
• Remove the light from the housing. Disconnect the wiring connector from the back of the light.
• Push the wiring connector onto the prongs at the rear of the new light.
• Place the new light in the headlight housing. Position it so the embossed number in the light lens is on the top.
• Place the retaining ring over the light and install the retaining ring screws. Tighten them slightly.
• Check the aim of the headlight and adjust it, if necessary.
• Install the headlight bezel. Secure it with the retaining screws.
• Connect the turn signal lamp wiring (if it was disconnected).

This means your air conditioner drain tube is clogged. This will take about a hour shop rate to repair or if you look behind the glovebox you will see it. Thanks