97 buick park avenue wiring drivers side door need to know what pins r witch ok the control modual has 5 plunins the middle one goes to the aoutmatic door locks. now when i got to it the modual was fried and the pig tale for the middle plug was cut off. so start with what is broken i replace the modual n the pig tale. now thats where my problem is on the pig tale all wires match up but there are 2 sets of wires that are both red dont know if it matters witch goes to witch n cant find a good enough diagram online so i can trace the wires from pin to pin, ie door lock to control modual so if any one out there has any wisdom to layon me plz help. oh yah the holes at the dealership where i live told me when i asked for a diagram laughed at me and said i should let the pros do the real work. thats not right i do real work everyday n at a much better price then the big box dealer ok enough of that if any one can help

SOURCE: 1998 buick park avenue drivers side blows cold, passenger side hot

sounds like the drivers temp door actuator is not working should be located on the drivers side of the air box down by the gas pedal or center dash area.

SOURCE: I have a '97 Buick Park Avenue Ultra front left growling noise

sounds like a wheel bearing if you don`t hear a clicking it is a bearing

SOURCE: power door lock switch replacement

Remove or Disconnect

Door handle trim plate.

1. .Install or Connect
   
   
2. Electrical connector and door lock cable.
3. Trim panel by engaging hooks on backside of panel.
4. Push pin fastener in defroster duct.
5. Screw from behind lamp assembly.
6. Courtesy lamp assembly.
7. Two screws in arm rest.
8. Arm rest cover plate.
9. Door handle trim plate.

1. Trim panel. See: Doors, Hood and Trunk\Doors
2. Four tabs retaining switch.
3. Electrical connector.

1. Electrical connector.
2. Snap switch into trim panel.
3. Trim panel.

SOURCE: Power windows and Power side mirrors Will not work.

i have had this issue before all i had to do is do a new ground, jumped the safety window lock, as well as expanding the metal clips in the wire con.

ZJ Limited

• 17989 Answers
• Posted on Apr 19, 2010

SOURCE: FUSE IDENTIFICATION FOR 97 BUICK PARK AVENUE

Several Fuse Panel locations there; all fuse's description can find it in 1997 Buick Park Avenue Owners Manual (page 331 and next).

Hope this help (remember comment and rated this post) TY for using Fixya.