I have p0743 p0138 p1763 and 1763 codes on 1998 dodge dakota v6 3.9 loss power

Question edited for clarity.
Question moved to model category.

Sensor issues or wiring to them.

Code P1391 Dodge CMP or CKP Signal Intermittent ...

AutoCodes https://www.autocodes.com > p1391_dodge
Engine Light ON (or Service Engine Soon Warning Light) · Lack/Loss of Power · The engine may be harder to start · The engine may stumble or stall.

Cam Sensor Failure Causing no Start or Stalling : Dodge ...

RepairPal.com https://repairpal.com > Problems > Dodge > Dakota
On 3.7L V6 and 4.7L V8 engines the camshaft position sensor may fail causing the engine to crank but not start or it can cause intermittent stalling.

Dodge Dakota Vehicles With This Problem

RepairPal.com https://repairpal.com > Problems > Dodge > Dakota
On the 3.9L V6 and 5.2L V8, an intermittent connection in the crank position sensor wire connector can cause poor engine performance or the engine may crank but ...

..

All those codes refer to the transmission on an automatic gearbox. Looks like there's a fault on the gearbox electrics.

P1765=Transmission 12 volt supply relay control circuit.
P0753=Shift Solenoid "A" Electrical
P0743=Torque Converter Clutch Circuit Electrical

P0743 torque convirtor circuit malfunction
P0753 3-4 shift solonoid

Hi MOOKIE,HERE'S A LINK TO YOUR P0743 CODE. P0743 OBD II Trouble Code

There is a code table here: Diagnostic Trouble Code Table ,hope help.

Don't know what to do? Explain that

You don't go to a repair shop ?

If you work on your own vehicles,
you would google the codes & learn
what they tell you

That said, you still won't be able to
diagnose & component test

Don't throw parts at it

P1391 is Electronic Brake Control rough road data not usable.
The data the computer is reading from the wheel sensors (maybe) is out of normal range.
I would clear the code and see if it returns.

The P0743 code is saying there's a problem in the torque converter circuit. Check the circuit and solenoid or take it to the dealer or good tranny shop.

I'd put off the misfire until the tranny issue is solved.

Good luck.

hi there
I would call autozone and see what the codes are refering to they will be able to tell you .. the fuel filter may be starting to clog or the fuel pump is starting to malfunction or a egr or pcv valve is malfunctioning //

dont know lots about this witout engine size but some have 1 coil per cylender possible coil is bad or plug 02 sensor will cause some problems but a miss fire will cause it to run like trash