- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The PCM is located just next to the 16 pin OBD2 diagnostic connector under the driver's side dash. The PCM is perpendicular to the firewall with the electrical connector facing downward.
Symptoms of a bad EGR valve are usually stumbling idle or the engine stalling when the car is warm (normal operating temperature). Find the EGR valve and locate the vacuum line attached to it. Start the engine cold and wait for it to warm up. When the engine starts to stumble, pull off the vacuum line. If the EGR is bad, the engine idle will stabilize and no longer stumble.
Remove the starter and jump the connections to a Battery to see if it spins. Make sure you connect positive to the positve end and the neg to the neg end. Hope this helps.
the horn is behind the passenger front fender. right in front of the tire. you need to remove the dust cover to gain access to the horn(s).
the picture was shot from underneath the car. you can not get to the horn(s) any other way.
Does the starter make any noise or click when you turn the key to start? If it does not, chk. battery could be bad, and battery cables could be loose or corroded. If there good and clean and battery is good try tapping starter see if it will turn and start if it does or still clicks starter bad. It could be ignition switch if it does nothing at all, but if it clicks most likely its starter.
×