How can I determine if there was a transmission recall on my acura, so i change it now?
They install an inline filter on one of the cooling lines as part of the recall
SOURCE: Find oil filter in engine of acura CL
back side of block under intake if its a 2.2 or a 2.3 if its a 3.0 its on the passenger side of engine bay if you turn the wheel you will be looking at it
SOURCE: transmission dipstick location
Sorry, I'm just now getting it to you. The dipstick is located on the passenger side of the car way down at the bottom. It should have a yellow handle. It's just to the right and down of the battery. Let me know if you can't find it still and I will get you a picture somehow.
SOURCE: how to locate the thermostat for a 1997 acura 2.2
Removal & Installation
If the hose is stuck, carefully use a pick to break the seal between the radiator hose and the housing. If the hose is deteriorated, replace it with a new one.
Remove the thermostat housing bolts
Pull the water outlet neck away from the housing
Note the installed position of the thermostat, then remove it
Some coolant may leak out of the housing as the seal is broken.
Many thermostat housing's are made out of aluminum alloy. A plastic scraper is very effective and will not harm such metals.
To install
A new gasket must be installed before installation
Install the thermostat with the air bleed valve at the top
Install the thermostat with the jiggle pin facing up. This acts as an air bleed and must be at the top of the thermostat to operate properly.
Testimonial: "thank you very much on the solution, didn't take as long as i expected!"
3,101 views
Usually answered in minutes!
my 97 acura cl will not pass inspection and the code po700 and po758 are coming up i dont know what to do
Its probly your intake is clogged up.. I had that same problem I had to put my whole and take off and clean my old and take and put it back on and the check engine light is out now that happened to be about 12 years ago I took it to the shop this time I did it myself
Its probly your intake is clogged up.. I had that same problem I had to pull my whole in take off and clean my in take and put it back on and the check engine light is out now ..that happened to be about 12 years ago I took it to the shop this time I did it myself
×