Stalling carn starts fine but from time to time it likes to stall when you put it into gear ir when turning the wheel....

Possible torque converter clutch issue. Is the check engine light on? If so, have it scanned for transmission codes. If the torque converter clutch is locked up when it isn't supposed to be, the vehicle will stall. Another thing to check is for coking on the throttle plate. Remove the hose that goes from the air filter box to the throttle assembly and look inside the throttle bore to see if it is dirty/black. If so, use carb cleaner and a toothbrush to clean while holding throttle plate open and remove as much carbon deposits as possible. This can affect minimum idle airflow and also cause a stall

Does it happen when you shift just to 1st
what is idle in park
when you turn on the ac in park does the idle go up a hair??

Yes, check iac.
Do It Yourself Diagnosis and Repair

This sounds bad, even in neutral it stalls, you cant even push it. i would start by putting the transfer case selector in neutral and see if it rolls, if this jeep is only two wheel drive then start by jack the front wheels up and do this for the four wheel drive also, this is to see if its in the trany or the wheel, check and see if you can spin the wheels in the front, if this is two wd then if the wheels dont spin then you have a problem with the brakes but what concerns me is that it stalls in neutral, i would have to say the problem is in the trany and if this is a stick shift trany i would say the clutch broke and will not release but when its in neutral it should roll. anyway do the same in the rear wheels, jack them up and see if the wheels move, if they dont then remove the driveshaft at the rearend and then see if the wheels move. if the wheels turn with shaft off then theres a problem with the trany oor transfer case if its 4wd, if its 2wheel drive then its something in the trany, if the wheels dont spin with shaft off then start truck and see if it still stalls but dont let it go into gear with driveshaft off you will not be able to stop driveshaft when disconnected, just see if it stalls in neutral. good luck.

sounds like a electrical problem somewere

try changing your tps sensor

you need to adjust the engion timing

torque convertor not unlocking u can unplug the wiring 4 the torque convertor on the transmission u can drive it fine after u unplug it or spend $1000 to have it replaced ur call

best thing is to put a diagnostic comp and check for any faults!! could be somethin simple like plugs and leads

Its possible it could be other things causing the problem, but seeing as you've checked most of the likely causes, it is most likely your Torque-Converter. The lockup clutch in your Stator-Fan located inside the Torque-Converter could be siezed, causing the car to stall.