2005 Ford Crown Victoria Logo
Anonymous
Anonymous Posted on Oct 22, 2011
Answered

I have an 05 interceptor the O/D light would blink then stop this past weekend the check engine light came on and now the O/D light just blinks i pulled the code it was P0747 Pressure Control Solenoid Stuck On i replaced the solenoid while i had the pan off i checked for metal shaving there wasn't any put the put it all back together cleared the code and started the car both the O/D light and the check engine were back on after a minute or so.So i broke the ****** back down tested all the solenoids and the harness that holds them together. i took my OB2 an test fire the all ****** solenoids and they work fine the ****** doesn't slip or anything like that. it shift points seem to be different side note my engine fan also runs the hole time the car O/D light is on and now my dome light will not cut on when i open the door at this point i am thinking ECM but i am up of suggestions

Answer This Question

2 Answers

Anonymous

Level 2:

An expert who has achieved level 2 by getting 100 points
All-Star:

An expert that got 10 achievements.
MVP:

An expert that got 5 achievements.
Sergeant:

An expert that has over 500 points.

  • Expert 252 Answers
  • Posted on Oct 29, 2011
Anonymous
Expert
Level 2:

An expert who has achieved level 2 by getting 100 points
All-Star:

An expert that got 10 achievements.
MVP:

An expert that got 5 achievements.
Sergeant:

An expert that has over 500 points.

Joined: Feb 19, 2011
Answers
252
Questions
6
Helped
101391
Points
721

The first thing I would do is disconnect the negative battery cable so everything can reset itself...leave it disconnected for 3 minutes then reconnect..I have seen this type problem before and this has cured it..clear all codes before you do this..Clear the codes dont start it then disconnect the cable...Try this and get back to me..........Hope this helps..........................Metalpoet

Thomas Smith

Level 2:

An expert who has achieved level 2 by getting 100 points
MVP:

An expert that got 5 achievements.
Scholar:

An expert who has written 20 answers of more than 400 characters.
New Friend:

An expert that has 1 follower.

  • Expert 189 Answers
  • Posted on Oct 26, 2011
Thomas Smith
Expert
Level 2:

An expert who has achieved level 2 by getting 100 points
MVP:

An expert that got 5 achievements.
Scholar:

An expert who has written 20 answers of more than 400 characters.
New Friend:

An expert that has 1 follower.

Joined: Jun 12, 2011
Answers
189
Questions
1
Helped
69539
Points
237

Check speed sensor,if it isn't reading correctly it might cause the check engine light to come on,the fan running could also ,you might check the coolant sensor,and mabe the thermostat for the fan,as for the dome light, maybe a fuse?, or the bulb blown?
the speed sensor ,(maybe ) might cause the shift points to be differant if it's reading the speed incorrectly.
hope this helps!

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Blinking ligh d 05 acura tl what
If you are talking about your check engine light that's blinking, that means you have a misfire big enough that if you continue driving your vehicle like that you can damage your catalytic converter. Get it checked asap
Read full answer
Jul 21, 2018 • Acura Cars & Trucks
0helpful
1answer

I have an 05 Suzuki Forenza that has a flashing check engine light. This started on Tuesday. Had the codes looked up. Car is driving shaky and dash lights are blinking. Any ideas?
fix the anti freeze leak --before you blow a head gasket

what your codes mean

Check Engine Light On, P0300 Random Misfire Code. A random misfire means your engine is misfiring, but that the problem is not isolated to one or two cylinders. It is jumping around in a random way from one cylinder to another. A random misfire code usually means the air/fuel mixture is running lean.

What the P0700 code means. P0700 is set when the PCM detects a malfunction in the transmission control system. This malfunction causes the vehicle to set a Check Engine Light and trigger a failsafe mode. Once the failsafe mode is set it will remain until the fault is repaired or normal operation is detected.

PO133 Oxygen Sensor Circuit Slow Response (Bank1, Sensor1)
Read full answer
Nov 25, 2016 • Suzuki Cars & Trucks
0helpful
2answers

Check engine light is blinking on and off
it indicates a problem and should be investigated immediately
it reports on the engine ( check oil level, water level, charge rate ) and transmission ( check oil level if auto and gear selection process)
have the fault codes run asap to determine if the problem is going to costly or just sensor failure
Read full answer
Jun 07, 2016 • 2002 Nissan Quest
0helpful
1answer

Blinking check engine light
Check Ur alternator!
Read full answer
Mar 04, 2015 • 2004 Isuzu Rodeo
0helpful
1answer

01 dodge stratus r/t when I start the car all the lights in the car light starts blinking once its running for a while it stops but when I'm going up hill they blink again
if your talking bout check engine light or ses meaning service engine soon light is blinking u have a cylinder that isn't firing, usually cause by ignition coil, but fuel injector, crank sensor can cause it but most times its a coil u can stop at any auto parts store get the check engine light read
Read full answer
Mar 07, 2014 • Cars & Trucks
0helpful
1answer

1998 Toyota Camry quit at a stop light and won't start.
407ec0c6-6132-455d-929c-e986d8cbd072.png
Good morning Sir,

I have problem with the1998 (2.2) toyota camry.
The car was idle for weekend (2 days) & the engine fail to start on Monday. The attahment show the indicator "blinking" in the dash panel.

Need help. Thanks.
Read full answer
Apr 18, 2013 • 1998 Toyota Camry
2helpful
1answer

How can i stop my oil light from blinking and beeping on my 05 jeep cherokee?
It blinks and beeps if the oil pressure is dangerously low , which could severely damage your engine. Hopefully it is just a faulty oil pressure sender unit. That is an inexpensive sensor that "measures" the oil pressure. Best case , engine fine , oil pres good , just a bad sensor.
Read full answer
Nov 06, 2009 • 2002 Jeep Liberty
1helpful
2answers

Misfire codes on my 2000 Jeep Grand Cherokee
Regardless of why the misfire is happening, the shop needs to find and make it right. If you don't return it to them, they can claim it's a new problem, unrelated to the work they did. As I don't have any idea if any sensors were imported with the new engine or if anything was damaged on install, I really can't comment past what I've said.
Hopefully you are dealing with a reputable competent shop...If so, aside from the obvious annoyance, they should definitely take care of the problem for you. I would check fluid levels to make sure that they are good and perhaps even check sensors to make sure they are all on securely but past that I would do nothing more. As far as driving, since you don't know what's wrong, I'd limit driving to only what's necessary but no more.
Read full answer
Jun 20, 2009 • 2000 Jeep Cherokee
2helpful
4answers

Cylinder 4 misfire on a 2000 crown victoria interceptor
first cylinder 4 is the last on the passenger side . first pull the coil out and check if there is water where the plug is. if there is take the water out and dry up the coil. if you find water you got a crack manifold or a bad intake manifold gasket. if there is no water replace the coil. good luck
Read full answer
Apr 10, 2009 • 2000 Ford Crown Victoria
0helpful
2answers

Oil light and brake lights blinks on and off and abs light is on
Just a idea. If the car is running at idle and the oil light blinks , it usually from low oil pressure. At a idle your seeing the light respond to the revolutions of the engine. ! thing to try is to replace the oil pressure switch on the engine block. And #2, Most causes in a VW is that the vehicle overheated at one time and weekend the oil pump,or massive amount of miles.
Read full answer
Jan 14, 2009 • 1999 Volkswagen Passat
Not finding what you are looking for?

View Most Popular

2005 Crown Victoria

  • Cars & Trucks

Related Question

Blinking ligh d 05 acura tl what

  • Acura Cars & Trucks

Related Topics

134 views

Ask a Question

Usually answered in minutes!

Popular Questions

2003 crown victoria fuse box diagram

2003 Ford Crown Victoria

Location of EGR valve for 4.6 liter engine

1992 Ford Crown Victoria

FUSE BOX DIAGRAM FOR A 97 CROWN VIC

1997 Ford Crown Victoria

Show me the right fuse

2003 Ford Crown Victoria

What is the wrench symbol

2006 Ford Crown Victoria

Check Out the Latest Top Trucks Report!
Check Out the Latest Top Trucks Report!

View all Fixya Reports

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...