SOURCE: Chevy S10 Pickup Starter. Removed the two bolts
you also have two or three wires holding the starter inplace.. remove the wires and your problem should be solved.. p.s. it is a tight spot so you will need to wig. it alot... good luck keith..
SOURCE: i need a 1987 chevy S10 vacuum hose routing diagram
Go to Autozone.com, become member, will give you repair manual,location of parts,diagrams.
SOURCE: need a wiring diagram for a chevy s10. brake
your power starts at the brake light fuse,check with a test light,then proceed to stop light switch on brake pedal under dash,one wire will be hot when when you check it with your test light, the other won't be until you press down the brake pedal then the power flows through to the second wire,if no power to second wire replace switch,if you have power remove tail light bulbs and check for power in side socket.
SOURCE: firing order for a 1999 chevy s10 pickup
I apologize for the late response...Due to the bad economic situation this site has had a substantial (+50%) increase in the number of questions being asked in the last four months.
I assume you have a 4.3L and not the 2.2L?
For the 4.3L:
Firing Order:
1-6-5-4-3-2
Cylinders:
6-----------5
4-----------3
2-----------1
(front of vehicle)
Distributor:
coil wire-->
-----6------->............<--------5-------
-----4------->............<--------1-------
-----2------->............<--------3-------
............(front of vehicle)
Let me know if this helped, or if you have additional information or questions. Feel free to contact me at FixYa.com!
4,433 views
Usually answered in minutes!
×