1) listen if windshield wiper motor is turning when switched on. The motor is under hood up near firewall.
If no noise and fuses are OK, motor may need replacement.
2) If motor can be heard whirring, then maybe the plastic link between
the motor shaft and the wiper arm assy has worn or broken. (A very
cheap part). This can be accessed by removing cowling or vents in front
of windshield. This is a common failure.
The back window of the tailgate won't go down can hear the motor working
SOURCE: windshield washer
Most likely the washer pump motor has failed, unless your washer jets are plugged...
The washer pumps are known as a common problem. Remove the washer bottle & examine the motor. Is it cracked anywhere? If so, the motor will not work. Also, sometimes the connector gets corroded. Make sure that it is clean. Hope this helps.
SOURCE: Removing rear windshield wiper arm on 94 4Runner
on the wiper arm, there is a cap. remove cap and there is a nut underneath, remove nut spray wd40 oil on the threads that are exposed, then slowly wiggle arm and pull simultaneously to remove.
1,576 views
Usually answered in minutes!
my wipers stopped working today morning. i can hear the motor working and wiper fluid is also working. the only problem is that wipers are not moving.
where is the fuse for the windshield wipers
windshield wiper motor on with switch off on 2000 toyota tundra
Windshield wipers intermittent stops in various positions, often straight up. They resume and again stop in strange position.
wipers don't work but sprayer doeb/1995 merc sta wgn
windsheild
wiper not working
windshield wiper change
×