2004 Subaru Outback Logo

Related Topics:

Anonymous Posted on Oct 16, 2011

2002 subaru outback 2.5 dies at idle... - 2004 Subaru Outback

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

  • Contributor 1 Answer
  • Posted on Mar 31, 2012
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Joined: Mar 31, 2012
Answers
1
Questions
0
Helped
177
Points
1

Fuel Filter needs to be changed...

5 Related Answers

Anonymous

  • 1 Answer
  • Posted on Oct 09, 2008

SOURCE: what oil grade do i need in 2002 subaru outback?

Probably 5w40 synthetic

Ad

Anonymous

  • 133 Answers
  • Posted on Jan 09, 2009

SOURCE: fuse box location on 2002 Subaru

my books say there are two. one inside vehicle on drivers side below dash to the left of the steering wheel. the other is in the engine compartment on the drivers side by fender

Anonymous

  • 15935 Answers
  • Posted on May 23, 2009

SOURCE: needdrive belt diagram for Subaru outback 3.0

8c0dd6e.gif
Thanks for using FixYa - a FixYa rating is appreciated for answering your FREE question.

Anonymous

  • 377 Answers
  • Posted on Nov 11, 2009

SOURCE: Adjust the headlight beam on 2002 Subaru Outback

two screws on each headlight control the direction the headlights are aimed. One screw, usually at the top but sometimes below the headlight, adjusts the headlight up and down. The other screw, located to one side, controls the headlight from right to left. Turning the appropriate screw one direction or the other will change the direction the headlight points.
In order to aim your headlights you need to have a flat vertical surface you can aim your headlights at in front of a level surface on which to park the car. If your driveway is level your garage door is the perfect place to aim your headlights.
The tools you will need for this job are simple. Masking tape is used to mark where the headlights are to be aimed and a screwdriver is needed to adjust the headlights. A tape measure will be necessary to measure the distance of the vehicle to the surface you're using to check the aim and to measure the up and down distances from your marks

woozie38

  • 608 Answers
  • Posted on Apr 19, 2010

SOURCE: the serpentine belt broke on my2002 subaru outback

There is a distinct possibilty there is engine damage caused when the belt broke. It is best not to turn the engine at all once this happens. Sometimes you can be lucky and there be no damage. Let's hope that's so in your case. These belts are supposed to be replaced every 100,000km.

Download instructions from my website...

http://arraw.info/pdf/Timing Belt.pdf

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2002 Subaru Outback H6 3.0. I have a misfire on cylinders 1, 3, and 2.

Question edited for clarity.
Question moved to model category.

You have managed to mix up the firing order. Wrong plug wires to wrong cylinders

https://www.google.com/search?q=2002+subaru+outback+h6+3.0+firing+order+diagram

..
0helpful
1answer

Where is the fuse box for 2002 subaru outback tail lights

On this website you find fuse box diagram and description for Subaru Outback (2001 - 2002)

SubaruOutback 2001 2002 fuse box diagram Auto Genius
0helpful
1answer

My 2002 subaru outback starts just fine but dies within 10 seconds

sounds like a bad fuel pump.
its getting enough fuel to start then its starves after it starts
0helpful
1answer

Idle relearn for 2001 subaru outback

there are two ways your car controls its idle
the throttle position sensor and the idle air control.
if the idle is rough or wanders get the idle air control checked and cleaned up. its the most common poor idle fix
4helpful
1answer

The ABS,Brake Light,Battery light go on and off sporadically while driving.Does this indicate an Alternator failure or a sensor/computer problem?

yes it's most likely a alternator problem,usually the internal diode bridge breaks causing all lights you mentioned to come on,if this happens at a idle open the hood and remove green connector on alt.if lights go out you've found the problem
0helpful
1answer
Not finding what you are looking for?

187 views

Ask a Question

Usually answered in minutes!

Top Subaru Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...