After I shut the glove conpartment closed kinda hard my airbag light has been on ever since.

not sure of the tracker exactly, but every car I've ever delt with has the blower on the firewall on the passenger side. the heater core is behind the glove box. it's usually pretty easy to chage the blower, but make sure you check the fuses 1st. also test the wires to make sure it's getting power. may save some time and headaches.

under dash, i think rh side behind glove box on your model but its been a while since ive worked on one so im kinda guessing

all the fuses are behind the glove box.. there isn't a fuse for the airbag light. there is only a fuse for the whole cluster. just be safe and fix your airbag. you shouldn't be cheap when it comes to your life, if you cant afford an air bad don't drive.

There is a small fuse in the cab fuse block ,for the insterment panel that is verry easy to miss if you don,t look close ,it is hidden kind of at the top of the fuse block behind the wires,

HI there it's best not to mass with S, R, S system do to the sensitive of sensors .
you can tack your car R&S or auto zone they will scene the system and find witch
sensor is cousin mlf light to come on . OK

could be clogged fuel filter or bad fuel pump you should change your filter according to your manual in glove conpartment

if you removed all 6 screws. there are 2 on bottom. 2 on top and 2 in front on the side. pop out the light and release the electrical connector. then grab a hold of the glove box door from each side and pull hard. it will feel like your going to break it but it won't. you really have to pull on it kinda hard. right when your ready to stop cuz you think it will break just pull a little harder. you will be shocked when you see how much force is needed to get the glove box out.

there might be a key slot or button of some sort in the glove box with a red X over a airbag symbol try changing the position a few times see if the light goes off if not its a profesional job m8 sorry jezza

in he glove conpartment

The passenger side airbag is a lot easier then driver side. Take the glove box out and you will see two 10mm bolts holding it in place. When you open the passenger side front door, remove the panel on the side of the dash and you will see yellow connectors.The 1 closest to the front is attached to the air bag, it is clipped into the frame. Just pull it loose and take it out and your done. For the Driver side, it takes a skinny T27 to remove the two star bolts, then just disconnect the horn red clip and ground and install new airbag. The module is located under the passenger seat, underneath the carpet. Kinda stupid but thats where its at. You also need to replace the front impact sensor located behind the grille on the back side of the metal bar to each side. Follow the hood latch down. Also just to make sure, you know to disconnect the battery before you do all this. You don't want new airbags to accidentally deploy.