I have 2008 hyundai tiburon and yellow exclaimation light is on what does that mean?

Question edited for clarity, add maker and correct order.

Clutch Replacement Without Removing Sub-Frame

Hyundai Tiburon Forums https://www.newtiburon.com > ... > Transmissions Jan 22, 2021 - Briansmobile1 on YT put out a video detailing how to do a clutch job without dropping the whole subframe on a Sonata. Our subframe is supposedly ...

Clutch Install ' Hyundai Tiburon Forums
May 16, 2010
How much to replace clutch? - Hyundai Tiburon Forums
Apr 1, 2008
Installed clutch without dropping subframe
Feb 11, 2007
How long should a clutch repair take? - Hyundai Tiburon Forums
Nov 26, 2012
More results from www.newtiburon.com
..

You just go to the link I attached I'm sure you will get the solution of your problem -

HYUNDAI TIBURON COUPE 2002 2008 WORKSHOP REPAIR MANUAL

HYUNDAI TIBURON COUPE 2002 2008 WORKSHOP REPAIR MANUAL

for the best solution of your problem visit this site

HYUNDAI TIBURON COUPE 2002 2008 WORKSHOP REPAIR MANUAL

get your car fix right now

images for Where is the ECM fuse and Fuel pump ..

ECU fuse keeps blowing - New Tiburon Forum : Hyundai Tiburon ...

www.newtiburon.com/.../tiburon.../217243-ecu-fuse-keeps-blowing.html

Sep 8, 2012 - 18 posts - ‎8 authors
Edit: Instead, pull the fuel pump relay, and see if the fuse still blows when ... ControlRelay, Fuel Pump relay, A/T control relay, Generator, ECM ... Official "Check Engine Light" Thread - New Tiburon Forum ...
Jul 22, 2014
Fuel pump Relay
Apr 26, 2013
Starting problem. Fuel pump doesn't prime with key on.
Mar 9, 2013
Fuel pump not starting intermittently
Oct 6, 2010
More results from www.newtiburon.com

Car Cranks But Will Not Start - Hyundai Forums : Hyundai Forum

www.hyundai-forums.com/...2000.../85246-car-cranks-but-will-not-start...

Jan 17, 2008 - 10 posts - ‎6 authors

Removal & Installation

Specific to:
Hyundai Entourage 2007-2008

1. Before servicing the vehicle, refer to the Precautions Section.
2. Disconnect the negative (-) battery terminal.
3. Remove the crash pad lower panel (A).
   
   
   
   Fig. Remove the crash pad lower panel (A)
4. Remove the 2 screws (A) and the trip switch connector.
5. Remove the crash fascia panel (B).
   
   
   
   Fig. Remove the crash fascia panel (B)
6. Remove the screw with the ignition in the ON position (IG ON) and disconnect the 6P connector.
7. Remove the ignition switch (A).
8. Installation is the reverse of removal procedure.
   
   
   
   Fig. Remove the ignition switch (A)

Specific to:
Hyundai Accent 2006-2008
Hyundai Azera 2006-2008
Hyundai Elantra 2006-2008
Hyundai Sonata 2006-2008
Hyundai Tiburon 2006-2008

1. Before servicing the vehicle, refer to the Precautions Section.
2. Remove or disconnect the following:
   
   The negative battery terminalThe crash pad lower panelThe ignition switch after loosening the screw with IG ON and disconnecting the 6P connector
3. Installation is the reverse of the removal procedure.hope this helps it is off autozone website

Some malfunction there; I suggest scanned the PCM (computer) to know exactly what fault code is stored there, with this code number could send additional details to solve it.

Keep us updated.

need alternator.... perhaps? or most likely a blown fuse...which is an inexpensive fix

POSSIBLE EARTH PROBLEM. CHECK ALL EARTH POINTS ARE CONNECTE4D TO THE BODY AND ENGIN

hood vent door vent give me more specifics or go to collisionrepairadvice.com and go to information page