Need to know where the IAT sensor is in a Hummer 2006

Intake Air Temperature (IAT) sensor and Manifold Absolute Pressure (MAP) sensor are combined into a single assembly which is called Mass Air Flow (MAF) sensor. This MAF sensor is located on the air filter box near air filter hose, and is connected with a five wire connector. You cannot replace the IAT sensor alone. Instead a MAF sensor is replaced altogether.






Thank you for visiting Fixya.

This is the 2001-2012 Toyota Tacoma wiring diagram, Toyota Tacoma IAT (Intake Air Temperature) Sensor Location and the Toyota Tacoma MAF (Mass Air Flow) Sensor Location, also included is a pinout of the sensor. You are likely installing a performance chip or a cold air intake kit for increased HP (Horsepower). You will want to be sure to disconnect the car battery before adding performance products.




Here is the Toyota Tacoma's Iat sensor diagram:

IAT sensor is Intake Air Temperature sensor and goes in the air intake tubing. Don't know why it would tell you CAM sensor.

code po335 refers to crankshaft position sensor(CKP)--circuit malfunction===causes wiring--CKP sensor --ECM
check the air gap and rotor security . Check for dirt in the air gap. Change CKP sensor.
code po113 refers to intake air temperature (IAT) sensor ---circuit malfunction===causes ---wiring open circuit /short circuit to positive ---wiring short to ground---ground wire defective--IAT sensor ---ECM

You have to contact the mfg of that product

It won't do a thing for your vehicle

Waste of money & may do some harm

Send it back

If you have no instructions that should send up
a red flag & G Force never has them apparently

Give some more details of the problem.

depends on the engine...
3.7 liter, #1 below:



4.7 liter:



5.7 liter, #2 below:

Pink Black and white.black is power white is ground sometimes it has a green stripe and black is reference voltage.

Looking for the IAT on my G6. I know its in with the wires on my MAF sensor but of the 5 wires which two are the ones im looking for?