Non starter hyundai will not start even after continually turning the starter motor but will start with a push almost straight away. no fault codes on ecu can you help?

From your description it is definitely the starter motor sticking in the engaged position! Probably needs replacing, either the release spring is broken or needs lubricating!

Sounds like bad starter, solenoid contacts worn out

check that the starter wires are not crossed or a brake in them that if grounding them out

your starter is peobably going out brushes or solenoids wear out over time sounds like brushes inside the starter to me replace your starter

starter bendix is bad replace starter

Hello,

I read your problem. What I would do, is check your 02 sensor, that is part of your emissions, and related to the cadillac converter, this would cause some cut outs now and then, and some hard starts. Some time garage mechanics can not find this code that comes up, especially if it comes and goes. Thanks Mike from fixya.

The starting system consists of:

• starter motor
• starter switch, part of the ignition switch
• starter motor solenoid relay switch
• starter solenoid
• starter drive

When you turn your key to start your engine, it just clicks, right? If so, more than likely this is due to a bad battery. Even though your battery may appear to be fully charged, it may have a dead cell, or worse. If you get a jump, does the vehicle start? If so, replace your battery.

Possible sources of the problem if the engine does not crank or the relay clicks:

1. Battery
2. Starter motor
3. Starter motor relay
4. Ignition switch
5. Damaged fuse
6. Anti-theft system
7. Circuitry

I’m happy to help further over the phone at https://www.6ya.com/expert/jeremy_69f3cc28d95bf514

Check the starter relay.

the flash indicates a code count the number of blinks usually a shot blink 1,2,3and so on followed by another series of blinks and it may even give 2 or more codes depending write them down and look the code up on line it could indicate that a door is open causing this issue **** as a sensor is not reading correctly a few other ideas to start with its just a matter of breaking it all down one section of area at a time to figure out the cause

Turn the key on and wait 10 seconds. see if that helps, let me know if you will please