Ok bought 95 plymonth voyager 3.0l engine, the engine was running good as long as the weather is normally below 100 degrees. then what happens is the engine startes to stall, and then quits running. After about a half an hour the van will start again and then will run until it gets hot again. it follows the same problem again. Now the engine won't start, it turns over but doesn't fire, Any sugestions little addition i have changed the coil and tried starter fluid in manifold it tries to fire but won't run even on the ether.

SOURCE: Manual code retrieval for 1989 plymouth voyager 3.0 v6 engine

Hi Wayne, what you do is turn the key to the "on" position and back to "off". Do this three times. The engine light will flash. It will flash a certain amount of times, pause, then another set of flashes. The first set of flashes is the first number of your code. The second set is the second number. For example, you see 5 flashes, your first number of your code is 5, and so on.

SOURCE: engine runs good until hot then rpms go up and the

You need an egr valve/egr valve control solenoid. You can get them through Napa, Carquest or Dodge. You may also need the coolant temperature sensor (for the ECM) as it may have damaged this in the process. Very common problem on the 4 and 6 cyl Dodge engines.

Hope that helps.

Kevin

SOURCE: I have a 96 plymonth voyager the front wipers are

Did you check to see if the wiper motor is working turn the wipers on and you should hear it if it is working if not replace the motor