Dsc light is on now all the time - S-Type Jaguar Cars & Trucks

I DON'T KNOW - CONSIDER NEUTRAL SWITCH MAY BE PROBLEM. IF EQUIPPED WITH SHIFT LEAVER, VIGOROUSLY MOVE THROUGH ALL POSITIONS ABOUT 6 TIMES, TO SEE IF THAT CURES THE PROBLEM.
YOU DON'T WANT TO BE STUCK AND THIS NEEDS TO BE REPAIRED. ASK DEALER IF THERE IS A RECALL. DEALER MAY OFFER DIAGNOSTIC SERVICE. ANY MECHANIC MAY BE ABLE TO CHECK LIGHT CODES FOR CAUSES.

ABC/ASC/DSC lights on due to bad tires/wheel not centered ...

www.bimmerforums.com/forum/showthread.php?1568281...DSC...

Dec 5, 2010 - Thread: ABC/ASC/DSC lights on due to bad tires/wheel not centered? ... I was driving at highway speeds again. I drove the car for 10 mins, then ..... I cleared them. If the lights come back on, I'll scan with INPA and see what it reports. .... This was happening at low speeds on dry pavement. So something is ... Dsc - Bimmerforums
Feb 14, 2012
DSC blinking more sensitive since new tires - Bimmerforums
Oct 18, 2010
DSC is awesome...
May 1, 2004
More results from www.bimmerforums.com

Hi Melissa,

I had a similar problem with my 2005 RX8 but didn't try using the DSC button. I had to have my engine rebuilt....I'm in So Cal and found a great private mechanic, are you local???

Year, make and model of your vehicle would help. Do you have any codes in your ABS control module ?

DSC light only comes on.

The yellow light and DSC light is to warn the driver the traction control and DSC is set to OFF.

Put the car to park and take the key out should reset it back to normal mode. DSC = ON and TC = ON.

Is it possible someone hold the DSC selector down and disable the TC and DSC?


If my answer is useful then place rate it.

Thanks

MUSTGO

It is not your A/C the problem, try this:
1- Apply the brake.
2-Open ignition to on position II engine off.
3-make sure to set A/C to low temp with A/C button off.
4-Start the car while keeping foot on the brake.
5-push A/C button on and make sure that a/c compressor comes on and wait around 10-12 second.
6-Let foot of the brake and wait ,check if DSC light comes on if not pump the brake several time with A/C compressor on if light comes on, if it dose mean your MASTER CYLINDER BRAKE SENSORS NEED CHANGING.
This was the solution for my car,I had exact the same problem.

Abs and dsc are related and with the light on these won't work. It is possible that you need to go back to where the work was done to look this over.

There is a switch underneath that goes out due to the debris underneath. Either take it to the shop or deal with the lights comming on.