Need a key to start my vaan - Windstar Ford Cars & Trucks

How many miles since the last transmission fluid and filter changed? If never, then get it to a transmission shop and get them replaced. You can have the shop add a quart of Lucas Oil transmission fix with the rest of the new fluid.

You need two keys programmed the same, for an
Lincoln LS to start

One key is less than the fuel you put in the tank

Need the keys,no other solution & too complicated
a starting system to describe here & I have a 2004 LS

You get two keys & a valet, when the car is new

I bought a new key at the dealer & programmed
with the owners manual,need at least 3 keys for ALL
Vehicles

Replace the ignition switch

If the key is acting proper and lights are working good then there is a problem with the start system.need more info for proper fix.do you here click noise in start position? does lghts dim when key in start position?

your key may need to be re-programed to the car --- if you have both original keys then you should be able to flip both of them through the inginion and then the truck should start just fine,, but if one of the keys is a ' clone key ' then you are going to need to go to a automotive locksmith and have the keys and computer re-programed. do not go to the dealer -- they will charge you a lot more than the locksmith will. but try and flip the keys through first,, start with one key, put it in the ignition turn the key to the on position ( NOT start position ) -- wait a few seconds,, then put the next key in ( to the on position ) and wait a few seconds,, then got back to the first key and turn to the on position,, wait a few more seconds and the light should go out --- start the truck. again, you may need your trucks computer re-programmed and since you have the keys the cost will be cheaper than if you had no keys.

c...

sounds like a bad key switch. the key needs to go in start car then turn off and be removed. you say the key cannot be removed. Is the key still in there? if so you need a new key lock drum. and/or a new ignition switch behind the actual key lock.the key lock can be removed and the electric switch is down in there. once the key lock is out you can start with a screwdriver. the mew key lock will come with a new key and snaps right in. to remove the old key lock refer to a manual for procedure.

if the key is toast, you need a new key. that new key needs to be progarmmed to your ecu. both need to be at a bmw dealership with the car. the charge about $120 bucks to program the key.

Hello. Your smart key needs the battery replaced.

You can start the car, with a weak smart-key battery.

Position the smart key right above the start button. The Smart-key receiver will communicate with the smart key passively. The smart key must be held on the dash, above the start button.

If it's the same as the VATS system in my 86 Corvette (resistor pellet in key) the ignition switch might need to be replaced. The contacts on the key wore low, replacing the key helped for a short time but the new contacts wore the switch down faster then it too needed to be replaced. $200!

There is a chip in the key on the newer cars. The dealer should be able to send your information to Hyundai and order a new key. Pricey. Check with another dealer.