Clock radio 1990 doge dakota

• Turn the Dakota's ignition on. Find the "Time" button on the top part of the radio control panel.
• Push and hold the "Time" button. After a couple of seconds, you'll notice the hour display starts to blink.
• Turn the "Tune/Scroll" knob to adjust the hour. When the hour is correct, push the "Tune/Scroll" knob. Now you'll notice the minute display blinks.
• Turn the "Tune/Scroll" knob to adjust the clock's minute display. Push the "Tune/Scroll" knob to save the changes to the clock.

should check the manufacturers specs first

Sounds like the sounds of silence are the only thing this radio plays! Maybe you got a bad one.

How to set your clock stereo on 1992 Dodge Dakota

?Turn the vehicle on then push the SEL button. It should flash back and forth between the time and the radio station you are set to. Set it to the time position.
?Now push the SET button. On my original stereo a P comes up. ( I think the P means p.m. but I have not been able to figure out how to change that setting) Next try the SEL button. It should flash to the hour. Use the TUNE knob to scroll to the desired hour.
?Push the SEL button and you should be able to set the desired minutes the same way.
?Push the SEL button again and the clock on your vehicle stereo should be set.

there should be a small pin button you need to hold down to put the radio in set mode

Push one of the two bottom right buttons,then I believe you clock it up or down, with the top right channel select button,then the set button

The oil capacity should be 4 qts with filter change (approximate). Safely fill with 4 qts and new filter and run the truck for a few minutes. Let set a few minutes and add to fill mark on stick if need be. Hope this will help you.

Not sure but you may have a radio that needs a code input. the radio thinks it was taken out and a code needs to be put back in at the proper time. if you bought the truck new it should be in oners manual. if not you have to get it from a dealer. you may have to pay for it.

First things first, if you havent already done so, check the owners manual. If you lost it or dont have one, i suggest 1 of these 2 procedures:

1.) Next to the radio, there should be 2 little holes. They are actually buttons. One of these has hours or "h" above it, while the other is labelled minutes or "m". Use a pen to press those little buttons to set the correct time.

OR

2.) Use the knobs to tune the radio (AM/FM and volume) to set the time. This is how it works:

-Press and hold the Time button
-The "hours" on the display should flash
-Turn the radio tuning knob to set the correct time
-Press and hold the tuning knob
-The "minutes" on the display should flash
-Set the correct time

Then you should either wait for it to stop flashing or press the time button to set it.

Dodge Dakota http://www.installdr.com/Harnesses/DCP-Wiring.pdf
1991 Chevy Cavalier http://www.installdr.com/Harnesses/GM-Wiring.pdf
Here is a link that should help you get your radio wired up again, good luck.