Question about 2004 Chevrolet Venture Passanger

1 Answer

I have to replace shocks on back of my 2004 chevy venture and i'm putting air shocks on it and on instructions it says to put air inlet towards center of van ok my question is will there be enough room for inlet between metal plate that is behind shock or in front of shock where it is close to frame this has me confused cause not much room on either side of shock for the inlet for hose to connect too

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Chevrolet Master
  • 53,745 Answers

Change the hose connects from straight in to ones at 90 degrees
that should give you the required clearance

Posted on Aug 01, 2017

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: Thermostat in a 2003 chevy venture van

no you dont need a special tool you have to take the throttle body off it makes it sooooooo much more simple.

Posted on Jan 27, 2009

  • 3 Answers

SOURCE: 1991 Chevy Suburban - Cracked / Split Frame around RR Shock Mount

fasteddie383 is right. i had to do the same repair, to the same shock location, on my friend '81p/u. luckly i didn't have to take it to a welder, i just did it myself. as for making a patch, that's going too far, and isn't needed. i simply "vee'd" the cracks (on both the inside & outside of the frame) and filled in the cracks with the welder. after i ground the welds smooth-TAKE CARE NOT TO GO TOO THIN HERE!-i cleaned up the hole opening for the shock bolt and installed new shocks (which is what i was doing when i found the damage) and it's been mint ever since (this repair was done in July of 2003). good luck.

Posted on Feb 26, 2009

billie17
  • 84 Answers

SOURCE: need to add 13-4a freon to my 2000 venture chevy van. Where is the pressure hose located?

passengers side under the hood.....by the firewall.....

Posted on May 12, 2009

  • 1 Answer

SOURCE: Message on dash 96 deville service traction control

check the brake fluid and make sure caliber is full of fluid. mine said that and it was because fluid was low.

Posted on Jun 14, 2009

dnewcombe1
  • 1564 Answers

SOURCE: Venture van power door problem

It sounds as though one of the proximity sensors is faulty. Also try giving the tracks for the door a good shot of white spray lithium grease. The door may be binding enough so that the emergency reverse is kicking in.

Posted on Jul 30, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

On a 2000 venture can you take off air shocks and put on reg shocks


Do an Internet search for kits that replace the air ride suspension, they are available from several suppliers I think. You can't just put in regular shocks as the car would set on the ground.

Jun 27, 2016 | Cars & Trucks

1 Answer

Chevy Venture Turns on but shuts off


fuel filter,dirty throtle body,air filter,IACV.

Jan 30, 2013 | 2004 Chevrolet Venture Passanger

1 Answer

My 2004 chevy venture won't start. Changed the


Did the fuel pump come on?

Did you check fuel pressure at the motor?


Try jumping the relay to get pump on?

Read a wiring diagram-- so you know what your doing?

Check Power & Grounds to pump when the tank was down?

Dec 22, 2012 | Cars & Trucks

1 Answer

MIdas put new shocks on front and back of 2003 chevy venture, now they say the noise is the front axle-help


get a second opinion from an accredited service shop that has experience on your vehicle
sound like the mechanics at Midas are just parts replace and see you as a sucker customer

Jul 08, 2017 | 2000 Chevrolet Venture

2 Answers

2004 Chevy Venture will not shift into gear


Had neighbor look at this same problem. Turned out the shifter cable linkage near the top of transmission had popped off. They popped it back on and works but a bushing in the clip probably needs replaced. The neighbor rewched over engined top between firewall and engine and popped it back on.
Works fine but does needs a clip/bushing part and auto parts store has to get from Chevy

May 18, 2010 | 2004 Chevrolet Venture Passanger

1 Answer

POWER !


check your transmission fluid levels they may be low, and replace the spark plugs you know give it a good tune up! wires, air filter, fluids, clean throttle body, IAC sensor, check for Vacuum leaks; like cracked hoses that lead to your map sensor or EGR valve etc.

May 14, 2010 | 2004 Chevrolet Venture Passanger

1 Answer

How do you change the battery on a 2004 chevy venture


You have to remove the round support bar. Two bolts in front one back by hood hinge. The bar slides out of the relay box, and the relay box lays over toward the motor.
There is a hold down on the backside of the battery at the bottom that needs to be removed, then take battery posts bolts out. Remove the battery put new one in, put the hold down bolt back in.
Connect battery posts up lay the relay box back put the round support bar back thru it put bolts in it and tighten everything back up and you are done.
Thank you for using fixya

Apr 07, 2010 | Chevrolet Venture Cars & Trucks

1 Answer

2004 H2 sometimes when I go to my hummer the back end has sunk down. it pumps up as soon as I stat it


Either you have an air line leak or one of your shocks are leaking air. Soapy water can be used to check both problems. Put soapy water on the air line connections and if there are bubbles then that connection is leaking. If you don't find any air line leaks then put soapy water around the shaft goes into the body of the shock and again if you have air bubbles that shock is leaking. It is always best to replace shocks in pairs. In other word replace all of the shocks on an axel even if you just have to replace one. Please rate my answer for helpfulness.

Dec 30, 2009 | 2004 Hummer H2

2 Answers

2001 Chevy Venture weak front A/C blowers


YOur problem is most likely a plugged cabin air filter, any oil chane place can replace the filter for $25.00 or less.

Aug 03, 2009 | 2001 Chevrolet Venture

1 Answer

Air shocks gone out leaning towards back


Yes you can put regular shocks on. You can get them from any local parts store.

Aug 13, 2008 | 1992 Lincoln Continental

Not finding what you are looking for?
2004 Chevrolet Venture Passanger Logo

Related Topics:

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85111 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...