Engine Wire diagram for S10

Chevrolet S10 Pickup Truck Car Stereo Wiring Diagram

Car Radio Battery Constant 12v+ Wire: Orange
Car Radio Accessory Switched 12v+ Wire: Yellow
Car Radio Ground Wire: Black
Car Radio Illumination Wire: Gray
Car Stereo Dimmer Wire: Brown
Car Stereo Antenna Trigger Wire: N/A
Car Stereo Amp Trigger Wire: N/A
Car Stereo Amplifier Location: N/A
Car Audio Front Speakers Size: 4? x 6?
Car Audio Front Speakers Location: Dash
Left Front Speaker Positive Wire (+): Tan
Left Front Speaker Negative Wire (-): Gray
Right Front Speaker Positive Wire (+): Light Green
Right Front Speaker Negative Wire (-): Dark Green
Car Audio Rear Speakers Size: 4? x 10?
Car Audio Rear Speakers Location: Rear Corners
Left Rear Speaker Positive Wire (+): Brown
Left Rear Speaker Negative Wire (-): Yellow
Right Rear Speaker Positive Wire (+): Dark Blue
Right Rear Speaker Negative Wire (-): Light Blue

and also

Stereo Wiring Diagram for 2000 Chevy S-10 - The12Volt

https://www.the12volt.com > installbay > forum_posts
Jul 3, 2005 - I'm hooking a few things up to my friend's S10, and we need a wiring diagram that shows what wire colors are what wire.
8 posts · try this..... http://www.installdr.com/InstallDocs/GM/PDF/460001.pdf. The Saint. Pioneer

..

I looked at wiring diagram for your vehicle, 2,5L engine, coolant temp sensor. The diagram shows two wires for the sensor.

The firing order is 1 6 5 4 3 2

The driver side bank from front to back, cylinders numbered, 1 3 5.
Passenger side bank from front to back, cylinders numbered, 2 4 6.
engine code w and x.

Sorry I have the tech to send diagrams .
However I do have the factory manual for this engine .
Why don't you send some more information and likely I can solve your problem

2000 Chevrolet Lumina 3.1 liter V-6 VIN "J"




Hope helps.

GET A PIECE PAPER DRAW A LARGE CIRCLE TOP UPPER HALF CIRCLE LEFT TO RIGHT WRITE NUMBERS 1 AND 3 BOTTOM HALF CIRCLE LEFT TO RIGHT RIGHT NUMBERS 2 AND 4 THAT YOUR DISTRIBUTOR SPARK PLUGS WIRES LOCATION.STANDING ON SIDE OF ENGINE WHERE DISTRIBUTOR IS LOOKING DOWN AT DISTRIBUTOR 1 AND 3 FIRST TWO SPARK PLUGS TERMINALS NEXT TO ENGINE. AND 2 AND 4 SPARK PLUGS TERMINAL ON CAP FACING YOU. THIS IS CYLINDERS LOCATIONS STANDING IN FRONT OF ENGINE.RUN WIRES FROM DISTRIBUTOR CAP TO PLUGS TO THE ENGINE SPARK PLUGS.

This should be the firing order diagram for that vehicle and engine, and please let me know if the coil packs are not correct. Also let me know if you need any help to understand this diagram, or if you require any further assistance.

For 3.8L
Firing Order:
1-6-5-4-3-2
Cylinders:
(back of engine)
2-------4--------6
1-------3--------5
(front of engine)
Ignition Connectors: there is 3-official options:
Type I:
(back)
6...2...4
3...5...1
(front)
Type II: There are two (2) official layouts for this:
..........(back)
|.6..3.|.|.2..5.|.|.1..4.|
..........(front)
............OR
..........(back)
|.3..6.|.|.5..2.|.|.4..1.|
..........(front)

Let me know if this helped, or if you have additional information or questions.

991 Chevy S10 firing order
The firing order for a Chevy s10 depends on which engine you have.
1.9L engine the firing order is: 1-3-4-2 . Distributor rotates counterclockwise.
2.0L engine the firing order is: 1-3-4-2 . Distributor rotates clockwise.
2.5L engine the firing order is: 1-3-4-2 . Distributor rotates clockwise.
2.8L engine the firing order is: 1-2-3-4-5-6 . Distributor rotates clockwise.
4.3L engine the firing order is: 1-6-5-4-3-2 . Distributor rotates clockwise.