Axle shaft bolt should be torqued to 147 Ft Lbs plus 1/4 turn.
The six CV joint bolts should be 59 Ft Lbs.
Ball joint nut should be 48 Ft Lbs
Hope this helps.
Thank you very much! For the lower ball joint though, i'm assuming the 48 Ft-lbs is for the 1 main bolt that holds the ball joint into the spindle, what about the 3 nuts that mount that ball joint to the control arm? Again, really appreciate the help.
The torque for the ball joint to bracket nuts are to be 47 Ft Lbs. This is whats specified and seems a little excessive I would use 40 Ft Lbs or a little less with some thread-locker. Try for 47 but if it looks like the threads are going to strip use less with thread-locker (Permatex).
Regards
Macanac
I'm re-posting reply. 47 Ft. Lbs is the specs. If it looks like the threads are going to strip use lower torque and some tread-locker (40 Ft Lbs or a little lower).
Macanac
×
814 views
Usually answered in minutes!
need flywheel and pressure plate torque specs
×