2000 vw jetta wipers move a little on the window then they stop is the relay bad or the motor

https://www.vehiclehistory.com/questions/whats-the-2011-vw-jetta-wiper-relay-location-299421

Possible relay or switch. But, set the speed to low and hit the motor to see if it engages.

Did you check the fuse? Have power at the plug? could be a bad ground.

New wiper motor needed the self park control is up the creek without a paddle,as its a 2000 model you may be able to repair it if you take the motor off and look under the gearbox cover you will find some copper strips ,this is the self park ? it may be easier to find another motor in the scrapyard

sounds like they need to be re-adjusted

Sounds more like it would be the wiper motor. If it was the relay they wouldnt move at all.

you "switch on" the relay to give you park, low, high speeds.......

there is a loose nut to the little electric motor, same thing happened to me or maybe your wiper motor went out if you can hear it moving then its just the loose nut

more than likely its the switch thats bad and its lost alot of the speed options

first try the fues box see if you have a blown fues, next if you put your wipers on can you hear the motor running for them? if you can the linkage has poped off from the motor, its a bit awkward to get it back on and no gaurentee that it will saty on, you might have to replace linkage, or, it might be the cogs on the actual wiper arms have splayed and are now smooth so they dont grip to move, you can take them off by the nut on the arm , get a can (coke can or simular) cut a rectangle out of it the hight and width if the cog, rap it round the cog, (make sure it does not overlap on the ends) and force the arm back into place and then do the nut up, this is just a short quick fix if that is the case you will have to replace the motor, also you can check the relay to the motor in the fues box, give it a tap a couple of times it might work again if not replace it...hope you find these sugestions helpful

probably a bad link see if you can find it by moving the driver wiper by hand if both move then the link to the motor is bad if only one moves either loose arm nuts or wiper to wiper link is bad