Low Beam headlights not working. All other lights work including DRL, High Beams, interior, fog and etc. Fuses okay. 2006 Buick Ranier

Question edited to add maker.
Question moved to model category.

Here is one idea and some videos.

https://www.justanswer.com/acura/6uky3-acura-mdx-low-beam-headlights-will-not-on.html

Sounds like two separate problems. For the headlight, check the headlight relay in the underhood fuse box (may be more than one if you have DRL), but may also be the headlight switch. For the dash lights, there may be a dead spot on the brightness control. Rotate it a few time to see if that fixes the problem.

find the low beam light relays
by law the fog lights can only come on with low beam
using fog lights on high beam is *******

These trucks are known for bad multifuction switches.
the switch that i talk of is the signal switch , the handle is the switch, it bolts to side of steering column . this switch controls the signals and the headlights and high /low beams. the other thing is the headlight switch connector, the connector some times goes bad and starts to melt or just comes out of the connector. you will need to remove the cover to steering column, the screws are located under the bottom cover in holes. remove cover and check connector and then test for power if you have power going into switch but not coming out then switch is bad.

the last thing is to make sure the bulbs are good , make sure the headlight bulbs are good , and also the driving light bulbs, test for power at the connectors to those lights to.
You will need to do a little testing to find the problem.

Replace the switch. The low beam side of the switch isn't making a connection.

Headlamps
The headlamps are operated when the driver places the headlamp switch in the HEADLAMP position. The LT HDLP and RT HDLP fuse in the IP fuse block, supply battery positive voltage to both the left and right headlamps. The low beam and high beam circuits continue to the headlamp switch. Depending on the position of the dimmer switch, either the low or high beam circuit will now have a path to ground. Ground is provided at G204. The low beam and high beam circuits also provide the body control module (BCM) with both low and high beam inputs. The headlamp switch includes the dimmer and the flash-to-pass switch.
If the headlight switch is left in the HEADLAMP position, the headlights will remain on until turned off or the battery runs dead.
Daytime Running Lamps (DRL)
Any function that turns on the headlights will cancel the daytime running lamps operation. The LT HDLP fuse in the IP fuse block supplies battery positive voltage to the daytime running lamp (DRL) relay coil circuit. The DRL relay switch contacts are connected to the low beam circuit. When the headlamp switch is placed in the OFF position, the BCM will turn on the daytime running lamps. The BCM energizes the DRL relay, closing the switch contacts and grounding the low beam circuit at G204. The DRL illuminate the low beam headlights at a reduced intensity. The DRL will operate when the ignition switch is in the RUN position, the gear selector is not in the PARK position and the parking brake is released. When these conditions have been met the DRL will illuminate.
DRL operation in Manual Transmission equipped vehicles will occur when the ignition switch is in the RUN position, and the parking brake is released.

Probably the dimmer switch . But without testing that would be just a guess . Turnning the headlamps on Any function that turns on the headlights will cancel the daytime running lamps operation..
No ,don't think the DRL relay has anything to do with it .

View wiring diagrams an testing the electrical circuits at the dimmer switch would be the proper way to diagnose .

hi try checking the relays the 1 for the low beam may be faulty

high low switch is gone or both low beams bad

hi beam/lo beam/DRL may be on separate fuses. Check your DRL (Day Running Lite) fuse